Robotic vacuum cleaner Model: R440 Operation Manual Important Safety Instructions To reduce the risk of injury or damage, read these safety instructions carefully and keep them at hand when setting up, using, and maintaining this device. WARNING SYMBOLS USED This is the safety alert symbol. This symbol alerts you to potential hazards that could result in property damage and/or serious bodily harm or death. This device can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of this device in a safe way and understand the hazards involved. Children should be supervised to ensure they do not play with this device. Cleaning and maintenance shall not be performed by children without adult supervision. This device is only to be used with the power supply unit provided. For the purposes of recharging the battery, only use the detachable power supply unit provided with this device. The battery must be removed from this device before this device is disposed of. To remove the battery from this device, first remove the screws on the bottom, then remove the battery by disconnecting the quick connector. The used battery should be placed in a sealed plastic bag and disposed of safely according to local environmental regulations. The external flexible cable or cord of the power supply unit cannot be replaced; if the cord is damaged, the power supply unit shall be disposed of. This device is for indoor use only. This device is not a toy. Do not sit or stand on this device. Small children and pets should be supervised when this device is operating. Store and operate this device in room temperature environments only. Clean with a cloth dampened with water only. Do not use this device to pick up anything that is burning or smoking. Do not use this device to pick up spills of bleach, paint, chemicals, or anything wet. 1 Before using this device, pick up objects like clothing and loose paper. Lift up cords for blinds or curtains, and move power cords and fragile objects out of the way. If this device passes over a power cord and drags it, an object could be pulled off a table or shelf. If the room to be cleaned has a balcony, a physical barrier should be used to prevent access to the balcony and to ensure safe operation. Do not place anything on top of this device. Be aware that this device moves around on its own. Take care when walking in the area where this device is operating to avoid stepping on it. Do not operate this device in areas with exposed electrical outlets on the floor. Do not expose the electronics of this device, its battery, or the integrated Charging Base. There are no user-serviceable parts inside. Do not use this device on an unfinished, unsealed, waxed or rough floor. It may result in damage to the floor and this device. Use only on hard floor surfaces or low-
pile carpet. This device has been designed to be used on floors without scratching them. We still recommend that you test this device on a small area of the room to be cleaned to ensure no scratches are made before cleaning the whole room. Notice This symbol on the device or its packaging indicates: Do not dispose of electrical appliances as unsorted municipal waste; use separate collection facilities. Contact your local authority for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-being. When replacing old appliances with new ones, the retailer is legally obliged to take back your old appliance for disposal at least free of charge. Contents Product Composition / Package Contents Product Composition / Part Name LED Display Function Dust Box, Water Tank and Charging Dock Product Usage / Preparation Product Use/ Robot Chariging Product Usage / Select a Cleaning Mode Time Scheduling Setting Mopping / Water Tank Cleaning and Maintenance Troubleshooting Product Parameter 2 4 5 6 7 8 9 10 11 12 15 18 19 Product Composition / Package Contents Robot Charging Dock AAA Battery Remote Handset Power Adapter Cleaning Brush Instruction Manual Side Brush X4 HEPA Filter X2 Water Tank Mopping Cloth Dust Box 3 Product Composition / Part Name Robot front view Drop Sensor Side Brush Robot back view Drive Wheel Dust Box Charging Contact Pins Omnidirectional Wheel Battery Compartment Rolling Brush 4 Magnetic Sensor Brush Guard Dust Box LED Display Function LED Display ICONS Function Description
5 6 Signal sensor DC socket DC socket Dust Box, Water Tank and Charging Dock Charging Dock Dust Box High Efficiency Strainer Primary Filter Strainer Dust Box Metal Sheet Water Tank and Mopping Cloth High Efficiency Top Cover Vent Dust Box Swivel Cover 7 Product Usage / Preparation Before using the Robot, remove the protective strip on the Robot and Charging Dock Remove Protection 8 Product Usage / Robot Charging Place the Charging Dock on a hard, level surface and against a wall. Remove objects within 1.5 ft/0.5 m on both sides and within 3 ft/1 m in front of the Charging Dock. Plug the adapter into the a wall outlet and plug the DC jack into the DC socket of the Charging Dock. When the Charging Dock connects to AC power, the LED indicator on the Charging Dock is flashing green. T Install the Charging Base in a location that Robot can easily access. Please place the Charging Base against a wall, and on a hard-level surface rather than on rugs or carpets.
- Always keep the Charging Base plugged in, otherwise Robot will not automatically return to it. 9 C W C D N L 5 Robot returns to the Charging Dock at the end of a cleaning cycle or when its battery is running low Caution:
Do not explode Charging Dock with direct sunlight or any strong reflection on light source. If cannot be avoided, please cover the bottom part of Charging Dock about 7 cm. Recommend to fully charge the robot to ensure operating time. Avoid to have Water Tank inserted in robot when charging. Avoid to have wet mopping cloth in which may damage wooden floor. Product Use / Select a Cleaning Mode 1. Auto Cleaning Robot optimizes its cleaning path by selecting different cleaning modes automatically until cleaning is complete. This is the most commonly used cleaning mode. Press on the Robot or start cleaning in Auto Mode
/
on the Remote Handset to T
- Robot will return to the Charging Base automatically when the battery level becomes low or when Robot is finished cleaning.
- By default, Robot starts in Auto Cleaning mode when it is turned on. 10 H D H Product Use / Select a Cleaning Mode H H Move forward Turn right Turn left Move backward 6. T
-Make sure the time is set correctly to your local time before setting a scheduled cleaning.
-Make sure the Robot is turned on 1 H 2 3 H 1 2 3 11 Mopping / Water Tank Do not use mopping function with any carpet floor Please remove mopping cloth and clean it after mopping is completed. Please empty the water tank after each use. j O x Press Power button to start mopping 12 Cleaning and Maintenance B x x D D x D x Robot Part Filters Rolling Brush Side Brushes Brush Guard Cleaning Frequency Once every week Once every week Once every month Once every month Sensors Charging Pins Swivel Wheel Once every month Once every month Once every month Replacement Frequency Every 2 months Every 6-12 months Every 3-6 months
(or when visibly worn) Every 3-6 months
(or when the silicone rubber strip on the brush guard becomes visibly worn) 13 Cleaning and Maintenance Do not allow water into the fan port during cleaning the dust box 14 T
-It is recommended to clean the primary strainer with water every 15 - 30 days after been used. The use life of the high efficiency filter screen is 3 months. 1. Before installing the filter screen, please ensure that the high efficiency filter screen and the primary filter screen are dry. 2. Do not expose the high efficiency strainer and primary strainer into the sun. Cleaning and Maintenance Water Tank and mopping cloth care W W 4U W v 5D W 15 1 2 3 4 5 3 T Only use the side brushes when completely dried. 1 4 2 5 16 please use dry dishcloth for cleaning, and do not use wet dishcloth to prevent damage caused by water. 17 Troubleshooting No. Prompt Tone Cause of Failure Solution 1 2 3 4 5 6 7 8 9 Wheels off the ground Dust Box not installed Robot suspended Dust box removed and not installed Battery failure Abnormal battery charging Please check if the wheel is stuck Wheel jammed Please check if the front bumper is stuck Front bumper stuck Robot's Wi-Fi connection failure Robot connected to server failure Please put the Robot back to the ground and press the cleaning key again. Return the dust box to the Robot and press the cleaning key again. Contact our customer service department to test battery. Check whether the wheel is entangled with foreign objects and clean up the entangled objects. Check whether the front bumper can rebound normally Check whether can access internet when connection is done The battery is low, please charge the Robot Please check whether the side brush is tangled or jammed Please move the Robot to the open area. Battery power less than 20%
Robot automatically enters the recharge mode Abnormal edge brushing Robot failed to get out of trouble Check whether the side brush is wound by wire and clean up the wound. Please move the Robot to an empty place and press the cleaning key again 18 Classification Structural class Battery parameter Robot Projects Diameter Height Net weight Voltage Battery Dust box capacity Charging type Cleaning mode Primary charging time Working time Rated power (w) Operating voltage ( v ) Parameter 330 mm / 1.08 ft 74mm / 0.25 ft 2.7 kg / 5.94 lbs 14.8 volts 3000 mAh rechargeable lithium battery pack 600 ml Automatic charging / Manual charging Auto / Single Room / Edge / Spot / Mopping About 300 minutes About 150 minutes 28w 14.8v
* Due to the continuous improvement of the product, this information product is subject to the physical object, and our company reserves the right to update the product. 19 Harmful Substance Cr(VI)Cr(VI) Cd/Cd compound compound PBB PBDE Pb/Pb Hg/Hg compound compound Component Plastic Hardware Host circuit module Electronic Battery Plug power cord
(Metal part)
: Indicates that the content of the hazardous substance in all homogeneous materials of the part is below the limit requirement
: Indicates that the content of the hazardous substance in at least one of the homogeneous materials of the part exceeds the Description: This form is prepared in accordance with the provisions of SJ/T 11364. specified in the current valid version of GB/T26572. limit requirement stipulated in the current effective version of GB/T26572, and there is no mature alternative in the industry, which meets the environmental protection requirements of the EU RoHS Directive. 10 The number in this logo indicates that the product has an environmental protection period of 10 years under normal use. GB4706.1-2005 GB4343.1-2009 GB4706.7-2014 GB17625.1-2012 Executive standard:
20 WARNING 1This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision 2the adapter must be removed from the socket-outlet before cleaning or maintaining the appliance. 3 the appliance must be disconnected from the supply mains when removing the battery;
4WARNING: For the purposes of recharging the battery, only use the detachable supply unit (model: GQ12-190060-AU ) provided with this appliance. WARNING
- English: "
This device complies with Industry Canada licence-exempt RSS standard(
s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device."
- French:"
Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement."
FCC ID2AT7J-R440 FCC Radiation Exposure Statement:
The transmitter must not be colocated or operated in conjunction with any other antenna or transmitter. This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body. FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment