EXOvault wireless charging stand instructions Plug into USB power adaptor. When charger is plugged in it is ready to accept phone. The charger will be in sleep mode using minimal power until it detects a phone has been placed on charger. Place Qi compatible phone on stand in vertical position to charge Place Qi compatible phone on stand in horizonal position to charge Phone will indicate the charging has begun. Phone will indicate when the phone is fully charged. Charger will automaticly stop charging when phone signals that the phone is full. Charger only works with Qi compatible phones. Non Qi phones will not charge on this stand. Instructions Page 1 FCC Warning Statement:
Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
.. Reorient or relocate the receiving antenna. . Increase the separation between the equipment and receiver. . Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. . Consult the dealer or an experienced radio/TV technician for help. Instructions Page 2