CONVERTIBLE CONVERTIBLE SPEAKER SYSTEM SPEAKER SYSTEM Owner's Manual PLEASE READ BEFORE OPERATING THIS EQUIPMENT. Model: CHT914c Size: 148.5(W) x 210(H)mm (A5) IMPORTANT SAFETY INSTRUCTIONS This unit has a long AC cord and other long cord that can easily be tripped on or pulled on, causing injury. Please make sure This unit has a long AC cord and other long cord that can easily be tripped on or pulled on, causing injury. Please make sure it is arranged so it will not drape over a laptop, etc. Where it can be pulled on by children or tripped over accidentally. it is arranged so it will not drape over a laptop, etc. Where it can be pulled on by children or tripped over accidentally. INSTALLATION This unit can be assembled as the following methods:
This unit can be assembled as the following methods:
Method 1: Assemble the main unit and L Speaker together :
3 4 1 2 Main Unit Left Speaker Supplied Wooden Stand Left Speaker Supplied Metallic Screws and Washers Lock the Hook on the rear of left speaker to the Main unit as Fig. 4 Note: We supplied total two Wooden Stands and 4 sets Metallic Screws/Washers.Keep the excess accessories in this assembly method for future use. Method 2: Assemble Main Unit and L Speaker individually :
1 2 3 Decorative Inserts Main unit Left Speaker Supplied Wooden Stand Supplied Metallic Screws and Washers 3 The speaker net can be take out and reassembly as the Figure below:
After above installation, connect the connection wires (Red and Black) from L Speaker to the Speaker Connectors on the rear of Main Unit as the figure below:
Black wire Red wire Left Speaker Main Unit
4 Indicator AUX IN 2 jack Remote Sensor VOL+ (Volume Up) button VOL- (Volume Down) button
/ TUNE + button TUNE - button
(Play/Pause) button SOURCE button
(Power) button EQ (Equalizer) button FM Antenna AUX IN 1 jacks POWER ON /OFF switch 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. LOCATION OF CONTROLS MAIN UNIT
1 2 3 11 10
9 8 7 6 4 5
12 13 14
5 LOCATION OF CONTROLS REMOTE CONTROL 1 2 3 4 5 6 7 8 1. POWER button 2. /TUNE - button 3. VOL (Volume)+/- buttons 4. SOURCE button 5. (Mute) button 6. / TUNE+ button 7. (Play/Pause) button 8. EQ (Equalizer) button 6 BATTERY INSTALLATION--- REMOTE CONTROL
-First Time Use Remove and discard the insulation tab from the battery tray as figure on the right.
-Replacing Batteries For Remote Control 1. Push and slide out the battery holder as figure 1 below. 2. Replace the battery with a new CR2025 button cell as the polarity markings on the rear of the Remote Control. 3. Close the battery holder. Fig.1 Fig.2 Fig.3
EFFECTIVE DISTANCE OF REMOTE TRANSMITTER
. Remote Sensor (on the front of the main unit)
Approx.15 feet 7 POWER SOURCE Insert the AC plug into a conveniently located AC outlet having AC 120V~ ; 60Hz. NOTE: The AC plug supplied with the unit is polarized to help minimize the possibility of electric shock. If the AC plug dose not fit into a non polarized AC outlet, do not file or cut the wide blade. It is the user's responsibility to have an electrician replacing the obsolete outlet. GENERAL OPERATIONS 1. Insert the plug from AC Power Cord into AC wall outlet having AC 120V~ ; 60Hz. 2. Press the Power ON/OFF switch on the rear of the Main Unit to ON position.The Red Indicator will light. Then press the Power button on the Main Unit or Remote Control to power on the unit from Standby mode. 3. Press the SOURCE button repeatedly to switch to desired mode.The indicator will turn to the corresponding color as below:
~ Green: Radio
~ Blue: Bluetooth
~ Purple: AUX IN 1
~ Orange: AUX IN 2 4. During Playback:
~ Press the VOL (Volume) +/- buttons to adjust volume level as desired.
~ Press the EQ button repeatedly to select and set equalizer mode as to Jazz; Pop; Classic or Rock. as desire. ( .)
~ Press the (Mute) button on the Remote Control to turn off the sound. Press again to resume. To reset the EQ to normal mode, power Off then power On the unit 5. When finished listening, press the Power button to . turn the unit to Power Off (Standby) mode. NOTE:
If long period of time will not use the unit, shut off the unit by press the POWER ON/OFF switch on the rear of main unit to OFF position or unplug the AC Cord from wall outlet. 8 LISTEN TO FM RADIO 1. Power ON the unit as previous procedures. 2. Press the SOURCE button repeatedly until the color of Indicator changes to Green. 3. Press and hold the /TUNE - or /TUNE + buttons until the indicator starts blinking. The unit will start to search next (or previous) available FM radio station then plays. 4. Repeat the same procedures until the desired radio station is received. NOTE: If the received FM station is in stereo mode, the unit will play it in stereo mode automatically. FM Antenna The Antenna wire on the rear of Main Unit is for radio reception. If reception is weak, unwind and extend the wire or relocate the wire to improve the radio reception. LISTEN TO TV/DVD/VCR/DVR Audio out jacks on TV/DVD/ VCR/DVR
DVD 1. Connect one end of supplied RCA audio connection cable to the AUX IN 1 jacks on the rear of the unit as the figure above. 2. Connect the other end to the Audio out jacks on the external player (such as Television, VCR, DVD Player, DVR ... etc.). 3. Power ON the unit as previous procedures. 4. Press the SOURCE button repeatedly until the color of Indicator changes to Purple. 5. Plays the music in the external player as usual. (Make sure the volume output level of the player is in high level. Otherwise, sound from this unit is weak). 9 LISTEN TO EXTERNAL AUDIO DEVICES AUX IN 2 jack
INDICATOR AUX IN 2 EQ SOURCE VOL-
VOL+
TUNE-
TUNE+
1. Connect one end of supplied audio connection cable to the AUX IN 2 jack on the top of the unit as the figure above. 2. Connect the other end to the Audio out/Line out/Phone jack on the external player (such like iPod, iPhone, iPad, MP3 Player, Discman... etc.). 3. Power ON the unit as previous procedures. 4. Press the SOURCE button repeatedly until the color of Indicator changes to Orange. 5. Plays the music in the external player as usual. (Make sure the volume output level of the player is in high level. Otherwise, sound from this unit is weak). 10 BLUETOOTH PARING AND PLAYBACK 1. Power ON the unit as previous procedures. 2. Press the SOURCE button on the unit or remote control until the indicator changes to Blue. 3. Turn on the BT function on the external BT device and play the music as usual. (Make sure the volume level of the external BT device is set to high level). 4. During palyback:
Press the VOL (Volume) +/- buttons to adjust volume level. Press the / TUNE- or / TUNE + button to skip track. Press the (Play/Pause) button to pause. Press again to resume normal playback. NOTES:
In first time use, pairing the external BT device as below:
A. Power ON the unit as previous procedures, press the SOURCE button repeatedly until the indicator turns to Blue and blinking. B. Power ON the external BT player and enter to searching mode. Start pairing as the on screen instructions on the external BT Player (For details pairing procedures, please refer to the users manual of your BT device.). C. When the external BT player searched the Speaker, our model number CHT914C will appear on the display of external BT device. Pairing code 0000 may need to enter. 11 TROUBLESHOOTING GUIDE
No power AC plug not connected to the wall outlet Plug to the wall outlet. Volume in minimum position Raise volume level by pressing the VOL
(Volume) + button No sound The connected device is not in payback mode Play the music/movie in the connected device as usual and make sure the volume level of it is in high level Input source incorrect Press the SOURCE button repeatedly to set the input source to the desired mode Sound distortion Remote not working Bluetooth reception failure Bass level of the connected device too high Reduce the bass level of the connected device Volume level too high Reduce the volume level by pressing the VOL (Volume ) - button The battery is consumed Replace with new battery The external device is far from the unit Put the external BT device close to the unit Have not paired Pair both unit as BT pairing page 12 GENERAL SPECIFICATIONS Power Source.......................................................................................................... AC 120V ~60Hz Power Consumption...................................................................................................................45W z Radio Coverage ...............................................................................................FM 87.5 -108.0 MH Impedance of Speakers:
Loud Speakers........................................................................................................ 8 Ohm, 10W x 2 Tweeters................................................................................................................... 8 Ohm, 5W x 2 Bluetooth Effective Range.............................................................................................Up to 30 feet
(Measured in open area. Wall and structures may affect the effective range.) Remote Effective Range...............................................................................................Up to 15 feet
1 x User Manual 1 x Remote Control 1 x CR 2025 Button Cell (For Remote Control, already installed) 1 x Stereo Audio Connection Cable with 3.5mm stereo plug 1 x RCA cable 4 x Assembly Screws / Washers 2 x Wooden Bases 13 LIMITED WARRANTY LIMITED WARRANTY Craig warrants this product to be free from manufacturing defects in material and Craig warrants this product to be free from manufacturing defects in material and workmanship under normal use for a period of 90 days from date of purchase. If service workmanship under normal use for a period of 90 days from date of purchase. If service is required, please return the product to the store where it was purchased for exchange;
is required, please return the product to the store where it was purchased for exchange;
or, pack the unit in the original packing material with all accessories if applicable, a copy or, pack the unit in the original packing material with all accessories if applicable, a copy of your sales receipt and a Cashiers check or Money Order for $15.00 (to cover shipping of your sales receipt and a Cashiers check or Money Order for $15.00 (to cover shipping and handling costs) payable to Craig Electronics Inc. For consumers in Canada, please and handling costs) payable to Craig Electronics Inc. For consumers in Canada, please make sure that the cashier check or money order is redeemable through a U.S. bank. make sure that the cashier check or money order is redeemable through a U.S. bank. Ship your product freight pre-paid. Your unit will be repaired, replaced or if the unit can Ship your product freight pre-paid. Your unit will be repaired, replaced or if the unit can not be repaired or replaced, a refund will be forwarded to you within four weeks of receipt not be repaired or replaced, a refund will be forwarded to you within four weeks of receipt of your unit. Please ship your unit to:
of your unit. Please ship your unit to:
Craig Electronics Inc. Craig Electronics Inc. 1160 NW 163 Drive 1160 NW 163 Drive Miami, Fl 33169 Miami, Fl 33169 This warranty is void if the product has been: a) Used in a commercial application or This warranty is void if the product has been: a) Used in a commercial application or rental. b) Damaged through misuse, negligence, or abuse. c) Modified or repaired by rental. b) Damaged through misuse, negligence, or abuse. c) Modified or repaired by anyone other than an authorized Craig service center. d) Damaged because it is anyone other than an authorized Craig service center. d) Damaged because it is improperly connected to any other equipment. improperly connected to any other equipment. Note: This warranty does not cover: a) Ordinary adjustments as outlined in the Owners Note: This warranty does not cover: a) Ordinary adjustments as outlined in the Owners Manual which can be performed by the customer. b) Damage to equipment not properly Manual which can be performed by the customer. b) Damage to equipment not properly connected to the product. c) Any cost incurred in shipping the product for repair. d) connected to the product. c) Any cost incurred in shipping the product for repair. d) Damage to the product not used in the USA. Damage to the product not used in the USA. This warranty is not transferable and only applies to the original purchase. Any implied This warranty is not transferable and only applies to the original purchase. Any implied warranties, including the warranty of merchantability, are limited in duration to the period warranties, including the warranty of merchantability, are limited in duration to the period of this expressed warranty and no warranty whether expressed or implied shall apply to of this expressed warranty and no warranty whether expressed or implied shall apply to the product thereafter. the product thereafter. Under no circumstance shall Craig be liable for any loss or consequential damage arising Under no circumstance shall Craig be liable for any loss or consequential damage arising out of the use of this product. This warranty gives specific legal rights. However, you may out of the use of this product. This warranty gives specific legal rights. However, you may have other rights which may vary from state to state. Some states do not allow limitations have other rights which may vary from state to state. Some states do not allow limitations on implied warranties or exclusion of consequential damage. Therefore, these on implied warranties or exclusion of consequential damage. Therefore, these restrictions may not apply to you. restrictions may not apply to you. To Obtain Service on your Product email:service@craigelectronics.com To Obtain Service on your Product email:service@craigelectronics.com Printed in China Printed in China CVD601-IB-E0CR1-E0US CHT914c_WC_E0CL1_V0US Size: 148.5(W) x 210(H)mm (A5) FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
receiver is connected. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the xperienced radio/TV technician for help. Consult the dealer or an e