5000 mAh Wireless Power Bank Instruction Manual SM-2822 Powerbank ON/OFF Button USB Output 1 Micro-USB Input USB Output 2 LED Indicator Wireless Charging Surface Features:
1. 2. 3. 4. 5. 6. Whats included:
1 x 5,000 mAh Wireless Power Bank 1 x USB to Micro-USB charging cable 1 x Instruction Manual 5000mAh/3.7V/18.5Wh Input power: DC 5V/2A Output 1/Output 2: DC 5V/2A Max Wireless Output: 5W LED Indicators Press the Powerbank ON/OFF Button(1) once to view the remaining power capacity. Press the button twice to turn OFF. 100 66 34 INSTRUCTIONS:
1. Charging the PowerBank:
Charge the powerbank fully before usage. Connect the provided charging cable to a power source and to the micro-USB Input port(3) on the powerbank. Once connected the LED Indicator(5)will 2. 3.
**
Charging Electronic Devices with the Power Bank:
Connect the charging cable to your mobile phone/device using the appropriate connector. Connect the USB part of the cable to either USB Output 1 or USB Output 2, the LED Indicator will illuminate when charging. Remove the charging cable from your mobile device when fully charged. Charging Electronic Devices with the Wireless Charging:
PressPowerbank ON/OFF button(1) LED indicator will show Green once the powerbank is in wireless charging standby mode. Place wireless charging enable device on Wireless Charging Pad. The device will begin to charge, LED indicator will turn RED when charging. an unknown object is being detected between the wireless charging pad and the phone by FOD(Foreign Object Detection).
(The device will not begin to charge until object is removed.) SAFETY PRECAUTIONS:
WARNING-When using this product, basic precautions should always be followed:
Read all the instructions before use. Never store or use this product in temperatures below 32F (0C) or above 115F (45C). Do not overcharge your phone. The unit may become hot under excessive use. Remove your phone once it is fully charged. Never charge your phone for more than 7 hours at a time. The unit will only achieve full performance after 2 or 3 completed charge and discharge cycles. To reduce the risk of injury, close supervision is required when the product is used near children. Do not expose the device to moisture. Do not use the device in excess of its output rating. Overload outputs above the Do not use the device if damaged or 1. 2. 3. 4. 5. 6. 7. 8. 9. explosion or risk of injury. Do not disassemble the device. For 10. professional. Incorrect reassembly may 11. or temperatures above 104F (40C) may result in explosion. To ensure product safety, ensure that 12. identical replacement parts. Attachments on the back of your phone 13. can impede the effectiveness of the wireless charger, and lead to overheating. Please remove attachments from the phone before charging on this device. FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCCs RF Exposure guidelines, This equipment should be installed and operated with minimum 20cm distance between the radiator your body: Use only the supplied antenna MADE IN CHINA