PBTE103 User manual Specs for products Bluetooth version + SPECSBluetooth V5.0+EDR Support protocolHFPV1.2, A2DPV1.3,AVRCPV1.4HSP1.6,GAVDP1.2,IOP SNR(Signal to Noise Ratio): 96dB SNR stereo ADC and stereo DAC Sensitivity-80dBm<0.1%BER Transmitting distanceAbout 10m Frequency response2.4 -2.480GHZ Transmission powerCLASS24dbm Audio to SNR(Signal to Noise Ratio) 75dB Audio PerformanceSBC Battery Specs3.7V/60mAH(Built-in Lithium-Polymer Rechargeable Battery) Charging voltageDC5V 45mA Charging timeAbout 1.5 hours Working current40mA Standby current<50uA Temperature range-40C to +85C Play timeAbout 3.5 hours Talk timeAbout 3.5 hours Standby timeAbout 180 hours Function description Turning On of deviceLong press ON. Turning off of deviceLong press Off. 2 second onVoice promptPower 2 second onVoice promptPower Pairing status 1First time pairingBoot into pairing mode automaticallyVoice promptthe bluetooth device is ready to pair. Equipment open bluetooth connection interface optionPBTE103clik connectno password . After the success of the matching voice PromptThe bluetooth device is connected successfully. 2Re-pairingUnder off status long press blue LED flash alternately. 3For already connected device ,bluetooth headphone will automatically back to connect. Headphones into the matching status again . about 2 secondred and
Operation Guide Get through --------------------------------Short press Hang up -------------------------In a call short press Replay the last phone number -----------Double-click Play/Pause Music --------------------Short press Volume control to up and down ----Long press Song switch to up and down ----------Short press LED Light status 1Charging status -----Long bright red light,full charged red light off. 2Device on prompt-----Blue light on 3Pairing status-----Red and blue LED flash alternately 5Standby status-----Blue light flash 6Already connected status---Long bright blue light 7Play status-----Blue light bright 1 second and flash 1 time. Matters attention
Low battery prompt voice prompt Battery low. FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.