PBTH201 User Manual Specs for products Bluetooth version + SPECSBluetooth V5.0+EDR Support: A2DP, AVRCP, HSP, HFP, GAVDP SNR: 96dB SNR stereo ADC and stereo DAC Sensitivity: -80dBm0.1% BER Frequency: 2.4-2.48354G (Hz) Transmission Distance: 10m Transmission power: CLASS2, 4dbm Audio SNR: 75dB Audio performance: SBC decoding Battery Capacity: 3.7V/200mAH Charging Time: about 1.5-2 hour Charging Voltage: DC 5V Working currency: 40mA Working temprature: -40 to +85 Playtime(50% volume ): 5 hours Playtime(100%volume ):4 hours Standby time: about 300 hours Speaker Section Speaker Dimension: 40mm Impedance: 32 Rated Power: 15 mW Power capacity: 150mW Sensitivity: 103dB S.P.L/1KHz 2 second onpromptPower Off. 2 second on promptPower Frequency Response: 20~20KHz Function description Turning On of deviceLong press ON. Turning off of deviceLong press Pairing status 1First time pairingBoot into pairing mode automaticallyVoice promptthe bluetooth device is ready to pair. Equipment open bluetooth connection interface optionPBTH201clik connectno password . After the success of the matching PromptThe bluetooth device is connected successfully. 2Re-pairingUnder off status long press and blue LED flash alternately. 3For already connected device ,bluetooth headphone will automatically back to connect. Headphones into the matching status again . about 2 secondred
Operation Guide Get through --------------------------------Short press Hang up -------------------------In a call short press Replay the last phone number -----------Double-click Play/Pause Music --------------------Short press Volume control to up and down ----Long press Song switch to up and down ----------Short press LED Light status 1Charging status -----Long bright red light,full charged red light turn into blue. 2Device on prompt-----Blue light on 3Pairing status-----Red and blue LED flash alternately 5Standby status-----Blue light flash 6Already connected status---Long bright blue light 7Play status-----Blue light bright 1 second and flash 1 time. Matters attention Low battery prompt prompt Battery low. FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.