S31 User manual V1.0 Wi-Fi Smart Plug with Power Monitoring Specifications Model Input Output Current S31 120V AC 60Hz 120V AC 60Hz 15A max. for general use Operating temps Operating systems 0-30
(Android 4.1 & iOS 9.0) or higher Wi-Fi Material Dimension IEEE 802.11 b/g/n 2.4GHz PC V0 116mm(L)*70.4mm(W)*29.1mm(H) Product Introduction Configuration button/
Manual switch On/off LED indicator Wi-Fi LED indicator 1 Features S31 is a Wi-Fi smart plug with power monitoring that can be used to turn on/off devices from anywhere, schedule power on/off and share APP with your family to control. App Control Timing Schedule Voice Control Share Control Sync Status No Hub Required Smart Scene LAN Control Use Instruction 1 Download the APP eWeLink eWeLink eWeLink works with everything 2 2 Power on After powering on, the device will enter the quick pairing mode (Touch) during the rst use.the Wi-Fi LED indicator changes in a cycle of two short and one long flash. The device will exit the quick pairing mode (Touch) if not paired within 3mins. If you want to enter this mode, please long press the manual button for about 5s until the Wi-Fi LED indicator changes in a cycle of two short and one long flash and release. 3 Add the device Tap + to operate following the prompt on the APP. 3 Factory Reset Long press the pairing button for about 5s until the Wi-Fi LED indicator changes in a cycle of two short and one long ash and release, then the reset is successful. The device enters quick pairing mode (Touch). Please reset the switch to factory defaults if you want to use other Wi-Fi networks, then reconnect the network. FCC Warning Changes or modications not expressly approved by the party responsible for compliance could avoid the users authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 4 FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator& your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide r e a s o n a b l e p r o t e c t i o n a g a i n s t h a r m f u l interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. 5 Temperature:
Operating Temperature 0~30 Shipping and Storage Temperature: -40 to 60 Use Method: Plug and Play Software Class: A Overvoltage Category: II Pollution Degree: 2 Protection against Electric Shock:
Insulation-encased Class I Environmental: IP20 (NEMA 1) Automatic Action: Micro-disconnection (Type 1.B) 6