FCC ID: J75TPAS001D Wireless Dongle

 

Wireless Keyboard & Wireless Dongle Model: TPA-S001K+TPA-S001D User Manual TPA-S001K TPA-S001D 1. 2. 3. 4. OR Please turn on power switch. Note:

-Make sure your PC is ON and running when doing the pairing procedure.

-You dont have to pair ID again after changing batteries. Specification Wireless Keyboard Interface: Wireless 2.4 GHz & Bluetooth (HP 475 Dual-Mode Wireless Keyboard) Bluetooth (HP 460 Multi-Device Bluetooth Keyboard) Frequency band: 2402MHz-2480MHz Rating: 1.5V,10mA Maximum radio-frequency power transmitted: 10 mW Item Specification Operating Temperature 0 ~ +40 Weight RF Specification Frequency Modulation mode BT Channel RF Channel 2.4GHz GFSK 40CH 79CH Antenna Specification Chip Antenna Antenna Gain 0.6 dBi Power Specification Battery AAA * 2 Wireless Dongle Interface: Wireless 2.4 GHz Frequency band: 2402MHz-2480MHz Antenna Type:Chip Rating: 5V,100mA Maximum radio-frequency power transmitted: 10 mW Item Specification Operating Temperature 0 ~ +40 RF Specification Frequency Modulation mode Channel 2.4GHz GFSK 79CH Antenna Specification Chip Antenna Antenna Gain 3.49 dBi Power Specification Battery USB 5V Top View Bottom View Side View Label Specification:

Manufacturer Name: HP Inc. Corporate Address: 1501 Page Mill Road Palo Alto, CA 94304, USA CAUTION This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement:

The product comply with the US/Canada portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available. Contact:

For questions regarding this product, write to HP Inc. 1501 Page Mill Road Palo Alto, CA 94304 or call HP at 650-857-1501 To identify your product, refer to the part, series, or model number located on the product. Industry Canada Notice This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. SIMPLIFIED DECLARATION OF CONFORMITY TPA-S001K & TPA-S001D Hereby, HP, declares that the radio equipment: TPA-S001K & TPA-S001D is in compliance with Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following internet address: www.hp.eu/certificates

(search with Model Name ). Brazilian Notice

 

 

 

 

 

 

 

 

 

 

Sunrex Technology Corp Wireless Dongle Model : TPA-S001D Label Location Label Placement Location FCC ID Label Placement Location (EUT Top & Bottom View) Label Format

 

 

Authority to Act as Agent Date: June 8, 2023 American Certification Body, Inc. 6731 Whittier Avenue Suite C110 McLean, VA 22101 To Whom It May Concern:

______ AUDIX Technology Corporation ______ is authorized to act on our behalf, until otherwise notified, for applications to American Certification Body, Inc. (ACB). We certify that we are not subject to denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. Further, no party, as defined in 47 CFR 1.2002 (b), to the application is subject to denial of federal benefits, that includes FCC benefits. We also declare that the information provided to the FCC is true and correct to the best of our knowledge (47 CFR 2.911(d)) and we have been informed of the grantee responsibilities (47 CFR 2.909) with regard to certified equipment. Thank you, Agency Agreement Expiration Date: _____June. 8, 2024_____ By:

(Signature1) _____Honda Lin_______

(Print name) Title:

___Engineer _ On behalf of: _____Sunrex Technology Corp. ______

(Company Name) Telephone:

____+886-4-2568-6983_______ 1 - Must be signed by applicant contact given for applicant on the FCC site, or by the authorized agent if an appropriate authorized agent letter has been provided. Letters should be placed on appropriate letterhead. 102920 13

 

 

0

1

, 2 3 4

5

6

7

8

9

A B C A D C A

C

E F G H I J K I L M G N O N P Q R N H S

T

T

T

U U

V

U

T

W

X

Y

Z

V

U

U

1

T

X

V

U

U

T

7 T

V

U

T

W

U U

U

1 8

8

T

T

X

T T

1

T

U

U U

_ U

W 8

V

U

Y

Z

V

U

9

A B C A D C A

C

E F G H I J K I L M G N O N P Q R N H S Y

U U

Z a

T

T

T

T

X

T

U U

U U

c

b

T

b

8 U

X Y

Z

V

U

5

. 8

4

X

d

e N G f g h i G 5

j G P i G I I H

U

8

E F G H I J K I L M G N O N P Q R N H S 5

k k l m n m o p l k m l q k r s o l t v w x y z z

y

x y

w

w

v w

v w

w

y z w

w

w

y

w

y

v w x y z z

y

w

w

u u v

x y

w

w

v

v

w

y

w

w

w

w

z w

y

w

w

w

v

y

w

y

w

w

w

z w

w

w

v y

w

w

y

y

w

w

w

v w

 

 

 

 

 

 

Sunrex Technology Corp. No.475 Sec. 4 Chang-Ping Rd., Da-Ya Dist. Taichung City, 428 Taiwan Tel: +886 4 25686983 Fax: +886 4 25609979 U.S. Agent Designation for Service of Process ATTENTION:

Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 USA REGARDING: FCC Certification Section 2.911(d)(7) Information Designated U.S. Agent Company Name: Approve-IT, Inc. Contact Name: Nathan Grinager Street Address: 8011 34th Ave South, Suite 342 City/Province/Zip: Bloomington, MN 55425 Telephone No: 651-247-1678 Email: team@approve-it.net FRN #: 0027533835 This letter is to confirm that we (the Designated U.S. Agent) have accepted the responsibility to act as the Designated U.S. Agent for Service of Process as required by section 47 CFR 2.911(d)(7) on behalf of the Applicant noted below. U.S. Agent Signature:

Date:

June 16, 2023 Signed by (Printed Name/Title): Nathan Grinager / Co-President

*This letter is valid indefinitely for all applications submitted within the period of 06/15/2023 06/15/2024. The Applicant confirms its explicit consent and acknowledges that they must maintain an agent for no less than one year after terminating all marketing and importation OR the conclusion of any Commission-related proceeding involving the equipment. The applicant further acknowledges their responsibility to inform the FCC whenever the Designated U.S. Agent information above changes. Applicant Company name:Sunrex Technology Corp Grantee Code: J75 FCC ID: J75TPAS001D Contact Name:Honda Lin Street Address:No.475, Sec. 4, Changping Road, Daya Dist., City/Province/Zip:Taichung City,/N/A/428 Telephone No:886-4-2568-6983 #261 Email:honda.lin@sunrex.com.tw Applicant Signature:

Date:2023.06.15 Signed by (Printed Name/Title):Honda Lin/Engineer

 

 

 

 

 

 

Date: June 8, 2023 Request for Confidentiality Subject: Confidentiality Request for: ______ FCC ID: J75TPAS001D / IC: 7090A-TPAS001D ______ Pursuant to FCC 47 CFR 0.457(d) and 0.459 and IC RSP-100, Section 12.4, the applicant requests that a part of the subject FCC application be held confidential. Type of Confidentiality Requested Short Term Short Term Short Term Short Term Short Term Short Term Short Term Short Term Short Term Permanent Permanent *2 Permanent Permanent Permanent Permanent Permanent *3 Exhibit Block Diagrams External Photos Internal Photos Operation Description/Theory of Operation Parts List & Placement/BOM Tune-Up Procedure Schematics Test Setup Photos Users Manual ______ Sunrex Technology Corp.______ has spent substantial effort in developing this product and it is one of the first of its kind in industry. Having the subject information easily available to "competition" would negate the advantage they have achieved by developing this product. Not protecting the details of the design will result in financial hardship. Permanent Confidentiality:

The applicant requests the exhibits listed above as permanently confidential be permanently withheld from public review due to materials that contain trade secrets and proprietary information not customarily released to the public. Short-Term Confidentiality:

The applicant requests the exhibits selected above as short term confidential be withheld from public view for a period of __ days from the date of the Grant of Equipment Authorization and prior to marketing. This is to avoid premature release of sensitive information prior to marketing or release of the product to the public. Applicant is also aware that they are responsible to notify ACB in the event information regarding the product or the product is made available to the public before the requested period has expired. ACB will then release the documents listed above for public disclosure pursuant to FCC Public Notice DA 04-1705. NOTE for Industry Canada Applications:

IC currently only distinguishes Permanent Confidentiality exhibits as shown above. Short Term confidentiality is not considered applicable to IC applications. Sincerely, By:

(Signature/Engineer 3) (Print name) _____Honda Lin _______ 2 - The asterisked items (*) require further information to be provided to ACB before permanent confidentiality will beextended to these exhibits. Please refer to FCC KDB 726920 and the specific Document link for D01 found at:

https://apps.fcc.gov/oetcf/kdb/forms/FTSSearchResultPage.cfm?switch=P&id=41731 and review section II, 3) regarding specific information that must accompany these requests. 3 - Must be signed by applicant contact given for applicant on the FCC site, or by the authorized agent if an appropriate authorized agent letter has been provided. Letters should be placed on appropriate letterhead. 102920 13