210 mm x 90 mm, double side printed 299C K100
(Outside) Using your Wireless Car Charger 1. Unscrew the large socket nut and push vent clip ball joint into the hole until it snaps into place. 2. Screw the socket nut back on until tight this locks the vent clip onto the wireless charging pad and holds the adjustable support base in place. 3. Insert the USB-A plug into the car charger, then insert the USB-C plug into the wireless car charger. 4. VENT MOUNT Attach the mount by placing the vent clip bracket onto an air vent in your car and lock the mount by pressing down on the lever. NOTE: The lever has two settings. 1 is for thin vents, 2 is for thicker vents. If vent clip does not feel secure, adjust setting accordingly. SUCTION MOUNT Attach the suction mount by placing the it onto the dashboard or window in your car and lock the mount by pressing down on the lever. 5. Plug the car charger into the cigarette lighter socket to power on. The LED light on the wireless pad will be green when powered on. 6. Place your phone on the charging pad with the bottom of your phone resting on the support base, and the arms will automatically close and hold your phone in place. NOTE: Adjust the support base accordingly to ensure best charging position depending on your device. 7. To remove your phone, touch the button on either side of the mount and the arms will open automatically. User Manual Wireless Car Charger with Vent Mount and Suction Mount CAUTION:
Wireless charging works with ONLY Qi-enabled devices. 210 mm x 90 mm, double side printed 299C K100
(Outside) This device complies with Part 18 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION:
Changes or modications not expressly approved by the party responsible for compliance could void the users authority to operate the product. Note:
This equipment has been tested and found to comply with the limits for a wireless power charger, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technicia for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment could be installed and operated with minimum distance 0cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Specications Input: 5VDC/2A; 9VDC/1.67A Output: Up to 10W on select devices Charging distance: 6mm Soft pad to provide a stable surface Includes:
Car Wireless Charging Doc, Vent Mount and Suction Mount, Holder, VPC and cable. Compatible with all Qi-enabled devices. F000xxxR00