B-DB-AC Quick Start Guide B-DB-AC Quick Start Guide Package Contents Bullet AC Compression Seal Installation Requirements Shielded Category 5 (or above) cabling with drain wire should be used for all outdoor wired Ethernet connections and should be grounded through the AC ground of the PoE. We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti. For more details, visit ui.com/toughcable Surge protection should be used for all outdoor installations. We recommend that you use two Ethernet Surge Protectors, model ETH-SP, one near the B-DB-AC and the other at the entry point to the building. The ETH-SP will absorb power surges and safely discharge them into the ground. https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide
* Shown without antenna. Hardware Overview https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide Signal LEDs Ethernet LED Power LED Reset Button Ethernet Port In airOS, you can modify the threshold values for the wireless signal strength LEDs on the Advanced tab under Signal LED Thresholds. The default values are shown below:
The Ethernet LED will light steady blue when an active Ethernet connection is made and flash when there is activity. The Power LED will light blue when the device is connected to a power source. To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. This 10/100/1000 Ethernet port is used to connect the power and should be connected to the LAN and DHCP server. https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide Hardware Installation 1. 2. 3. https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide 4. 5. https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide 6. https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide 7. https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide Accessing airOS via Wi-Fi Verify connectivity in the airOS Configuration Interface using the UNMS app or Web Portal. Both are available for 15 minutes immediately after you power on the device. If necessary, you can power cycle the device to re-enable its Wi-Fi. UNMS App 1. Download the UNMS app. https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide 2. Connect your devices Wi-Fi to the SSID named: <model>:<MAC Address>
Note: Ensure that DHCP is enabled on your Wi-Fi adapter. 3. Launch the app and follow the on-screen instructions. Web Portal 1. Connect your devices Wi-Fi to the SSID named: <model>:<MAC Address>
Note: Ensure that your Wi-Fi connection has DHCP enabled. 2. Launch your web browser and go to: http://setup.ui.com 3. Select your Country and Language. You must agree to the Terms of Use to use the product. Click Continue. https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide 4. Create a username and password. Confirm your new password and then click Save. The airOS Configuration Interface will appear, allowing you to customize your settings as needed. For additional details, refer to the User Guide available at ui.com/download/airmax-
ac https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide Installer Compliance Responsibility Devices must be professionally installed and it is the professional installers responsibility to make sure the device is operated within local country regulatory requirements. Antenna Select your antenna from the list. Ensure Calculate EIRP Limit is enabled; transmit output power is automatically adjusted to comply with the regulations of the applicable country. For a Custom antenna, Antenna Gain is entered manually. Note the requirements and antenna types listed below. Cable Loss (When applicable) Enter the cable loss in dB. Output power is adjusted to compensate for loss between the radio and the antenna. Certified Antenna Types This radio transmitter FCC ID: SWX-BDBAC / IC: 6545A-BDBAC has been approved by FCC /
ISED Canada to operate with the antenna types listed below with the maximum permissible https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide gain for each antenna type indicated. Antenna types not included in this list or having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Frequency 2.4 GHz 5 GHz 2.4 GHz 5 GHz 2.4 GHz 5 GHz Gain 13 dBi 13 dBi 17 dBi 22 dBi 24 dBi 34 dBi Bullet AC Antenna Omni Sector Dish Specifications Dimensions Weight Enclosure Networking Interface Antenna Connector LEDs Max. Power Consumption Output Power Power Supply Power Method ESD/EMP Protection Operating Temp Operating Humidity Shock and Vibration Certifications US/CA Operating Frequency (MHz) U-NII-1 U-NII-2A https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
190 x 46 mm (7.48 x 1.81") 116 g (4.09 oz) Polycarbonate Gigabit Ethernet Port N-Type Connector Power, Ethernet,
(4) Signal Strength 7W 22 dBm 24VDC, 0.3A (Minimum) 24V Passive PoE
(Pairs 4, 5+; 7, 8 Return) 24 kV Contact / Air
-40 to 70 C (-40 to 158 F) 5 to 95% Condensing ETSI300-019-1.4 CE, FCC, IC 2400 - 2483.5 5150 - 5250 5250 - 5350 B-DB-AC Quick Start Guide Worldwide U-NII-2C U-NII-3 5470 - 5725 5725 - 5850 2400 - 2483.5 5150 - 5875 Safety Notices 1. Read, follow, and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in location that can be submerged by water. WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning. Electrical Safety Information 1. Compliance is required with respect to voltage, frequency, and current requirements indicated on the manufacturers label. Connection to a different power source than those specified may result in improper operation, damage to the equipment or pose a fire hazard if the limitations are not followed. 2. There are no operator serviceable parts inside this equipment. Service should be provided only by a The limited warranty requires the use of arbitration to resolve disputes on an individual basis, and, where applicable, specify arbitration instead of jury trials or class actions. qualified service technician. Limited Warranty ui.com/support/warranty Compliance FCC Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operations of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. This radio transmitter has been approved by FCC. ISED Canada CAN ICES-3(A)/NMB-3(A) This device complies with ISED Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
2. This device must accept any interference, including interference that may cause undesired operation 1. This device may not cause interference, and of the device. This radio transmitter has been approved by ISED Canada. The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems. CAN ICES-3(A)/NMB-3(A) Le prsent appareil est conforme aux CNR dISDE Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :
2. lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den 1. lappareil ne doit pas produire de brouillage;
compromettre le fonctionnement. Le prsent metteur radio a t approuv par ISDE Canada. Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont rservs uniquement pour une utilisation lintrieur afin de rduire les risques de brouillage prjudiciable aux systmes de satellites mobiles utilisant les mmes canaux. IMPORTANT NOTE Radiation Exposure Statement This equipment complies with radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 256 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. AVIS IMPORTANT Dclaration sur lexposition aux rayonnements Cet quipement est conforme aux limites prvues pour lexposition aux rayonnements dans un environnement non contrl. https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide Lors de linstallation et de la mise en fonctionnement de lquipement, assurez-vous quil y ait une distance minimale de 256 cm entre llment rayonnant et vous. Cet metteur ne doit tre install proximit daucune autre antenne ni daucun autre metteur, et ne doit tre utilis conjointement aucun autre de ces appareils. Australia and New Zealand Warning: This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment may cause radio interference. Brazil CE Marking Nota: Este equipamento no tem direito proteo contra interferncia prejudicial e no pode causar interferncia em sistemas devidamente autorizados. CE marking on this product represents the product is in compliance with all directives that are applicable to it. Country List AT IE BE IT BG LV CY LT CZ LU DE MT DK NL EE PL EL PT ES RO FI SE FR SI HR SK HU UK BFWA (Broadband Fixed Wireless Access) members noted in blue Note: This device meets Max. TX power limit per ETSI regulations. The following apply to products that operate in the 5 GHz frequency range:
Note: This device is restricted to indoor use only when operating in the 5150 - 5350 MHz frequency range within all member states. Note: All countries listed may operate at 30 dBm. BFWA member states may operate at 36 dBm. Note: Operation in the 5.8 GHz frequency band is prohibited in BFWA member states. Other countries listed may use the 5.8 GHz frequency band. https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]
B-DB-AC Quick Start Guide RoHS/WEEE Compliance Statement Declaration of Conformity Online Resources 2016-2019 Ubiquiti Inc. All rights reserved. https://dl.ubnt.com/qsg/B-DB-AC/B-DB-AC_EN.html[9/19/2019 4:39:22 PM]