FCC ID: SWX-U6EPIW Digital Transmission Radio

E-Label User Information FCC ID: SWX-U6EPIW IC ID: 6545A-U6EPIW Ubiquiti Inc. will be incorporating the E-Label procedures per FCC KDB 784748-D02. The information below is what will be included in the E-Labeling. E-label and warning statements can be found in the device/controller GUI under Device >

Settings > About. Detailed compliance information including Declaration of Conformity is available at the following internet address: ui.com/compliance FCC Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generated, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operations of this equipment in a residential area is likely to cause harmful interference in which case the user bill be required to correct the interference at his own expense. FCC regulations restrict the operation of this device to indoor use only. The operation of this device is prohibited on oil platforms, cars, trains, boats, and aircraft, except that operation of this device is permitted in large aircraft while flying above 10,000 feet. Operation of transmitters in the 5.925-7.125 GHz band is prohibited for control of or communications with unmanned aircraft systems. ISED Canada CAN ICES-3 (A) / NMB-3 (A) This device complies with ISED Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

1. This device may not cause interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3 (A) / NMB-3 (A) Le prsent appareil est conforme aux CNR dISDE Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes:

1. Lappareil ne doit pas produire de brouillage;

2. Iappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. RF Exposure Warning The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be located or operating in conjunction with any other antenna or transmitter. Les antennes utilises pour ce transmetteur doivent tre install en considrant une distance de sparation de toute personnes dau moins 20 cm et ne doivent pas tre localis ou utilize en conflit avec tout autre antenne ou transmetteur.

E-.. UNiFi (6) Enterprise In-Wall

(o NE Internet WiFi UniFi OS Console PoE GET ITON b- Google Play UniFi Network Get Answers help.ui.com UI Support G

Date: 08/01/2022 TIMCO Engineering, Inc. 849 N.W. State Road 45 P.O. Box 370 Newberry, Florida 32669 RE: Request for Confidentiality In reference to the application under FCC ID: SWX-U6EPIW, and pursuant to Sections 0.457(d)1(ii) and 0.459 of the Commissions Rules, Ubiquiti Networks hereby requests permanent confidential treatment of the accompanying information as outlined below:

Theory of Operation Software Security The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to Ubiquiti Networks and provide unjustified benefits to its competitors. It is our understanding that all measurement test reports, FCC ID label format and correspondence during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. Ubiquiti Networks understands that pursuant to Rule 0.457(d)(1)(ii), disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Mark Feil Ubiquiti lnc. Compliance Manager 685 3RD AVE. NEW Y0RK, NY 10071 www.ui.com

Date: 3 August 2022 Federal Communications Commission 7435 Oakland Mills Rd. Columbia, MD 21046 RE: Request for Class II Permissive Change FCC: SWX-U6EPIW It is hereby requested that Ubiquiti Inc. obtain FCC Class II Permissive Change certification of a radio apparatus on the Ubiquiti Inc. product U6-Enterprise=IW. The associated FCC: number is listed above. This Class II Permissive Change certification is to add UNII-2a (5260 MHz 5320 MHz) and UNII-2c

(5500 MHz 5720 MHz) frequencies bands. The addition of these NII bands is accomplished through firmware. The U6-Enterprise-IW is an in-wall mounted access point with four-stream WiFi 6 that provides up to 5.3+ Gbps aggregate throughput rate. The U6-Enterprise-IW has 2.4 GHz (2x2), 5 GHz (4x4) and 6 GHz (4x4) transmitters. The U6-Enterprise-IW has an Ethernet port for data transfer and is powered by an 802.3at PoE Power Adapter. The U6-Enterprise-IW has a Bluetooth management radio to achieve setup and operation. The U6-Enterprise-IW is designed for indoor use. Sincerely, Mark Feil Ubiquiti lnc. Compliance Manager 685 3RD AVE. NEW Y0RK, NY 10071 www.ui.com

Power of Attorney Date: 2021/01/20 Dear Sir or Madam, I hereby have entrusted the following entity to be an authorized agent regarding application for Type Certification. Ubiquiti Inc. also authorizes the following entity to be a proxy to handle all certification matters. Unified Compliance Laboratories Address : 427 W 128000 South Draper Utah 84020 e-mail : ucl@ui.com Applicant : Ubiquiti Inc. Address : 685 Third Avenue ,New York NY 10017 United States Of America Name and Job Title. : Mark Feil / Compliance Director E-mail : compliance@ui.com Tel. : 385-200-1617

Date:06/01/2022 Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 FCC ID: SWX-U6EPIW We, Ubiquiti Inc., attest that this device under FCC ID SWX-U6EPIW complies with device protocol requirements and operational restrictions: for indoor access point 6ID. Indoor Access Point 6ID:

1. Protocol attestation statement:

a. An 11ax IEEE devices Transmit Power Envelope element has information fields for the power limits for connection client/subordinate devices. The TPE information is contained in the device signals and used by connecting client/subordinate to ensure that it knows the regulatory TX powers it is allowed to transmit at. There is a regulatory info fields in this device beacon and probe response frames which details this device type when the client/subordinate associates to this device. 2. Statement acknowledging device restrictions:

a. Low-power indoor Access Point. Access Point operating in the 5.925-7.125 GHz band shall be supplied power from a wired connection, has an integrated antenna, is not battery powered, and does not have a weatherized enclosure. b. This device's operation will not be allowed on oil platforms, cars, trains, boats, and aircraft, except that operation of this device is permitted in large aircraft while flying above 10,000 feet. c. Indoor access points are prohibited for control of or communications with unmanned aircraft systems, including drones. Ubiquiti Inc. Compliance Manager 685 3RD AVE. NEW Y0RK, NY 10071 www.ui.com