5 GHz airMAX ac Radio with InnerFeed Technology Model: LBE-5AC-Gen2 Introduction Thank you for purchasing the Ubiquiti Networks LiteBeam5AC Gen 2 radio. This Quick Start Guide is designed to guide you through installation and also includes warrantyterms. Package Contents Antenna Feed Center Reflector Side Reflector Panels Panel
(Qty. 2) Feed Receiver Azimuth Mount Elevation Mount Metal Strap Knob Kit Gigabit PoE (24V, 0.3A) with Mounting Bracket Power Cord Quick Start Guide Products may be different from pictures and are subject to change without notice. TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet cable and earth grounding must be used as conditions of product warranty. TOUGHCable is designed for outdoor installations. It is the customers responsibility to follow local country regulations, including operation within legal frequency channels, output power, and Dynamic Frequency Selection (DFS) requirements. Installation Requirements 7 mm socket wrench or screwdriver Shielded Category 5 (or above) cabling should be used for all wired Ethernet connections and should be grounded through the AC ground of the PoE. We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrialgrade, shielded Ethernet cable from Ubiquiti Networks. For more details, visit www.ubnt.com/toughcable Application Examples The LiteBeam AC mounted outdoors with the reflector installed provides directional outdoor coverage (gain reflectordependent). The LiteBeam AC mounted outdoors without the reflector installed provides outdoortoindoor coverage using the 3 dBi Antenna Feed only. Hardware Overview Bottom View Technology LEDs Reset Button Ethernet Port Antenna Feed Reector Assembly Securing Arms Port Cover Feed Receiver Elevation Mount Azimuth Mount LEDs Ethernet The LED will light steady blue when an active Ethernet connection is made and flash when there is activity. Power The LED will light blue when the device is connected to a power source. Button Reset To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the LiteBeamAC is poweredon. The LiteBeam AC may also be reset remotely using the auxiliary Reset button located on the bottom of the Gigabit PoEadapter. Port Ethernet Supports 10/100/1000 connections and passive PoE. This port should be connected to the LAN and DHCP server.