NanoStation5 User Guide USER INSTRUCTIONS 1. Launch web browser and type 192.168.1.20 to access NanoStation 2. Enter "UBNT" for both username and password www.ubnt.com www.ubnt.com TECHNICAL SPECIFICATIONS Processor Specs Memory Information Networking Interface Wireless Modular Approvals RoHS Compliance SYSTEM INFORMATION Atheros AR2313 SOC, MIPS 4KC, 180MHz 16MB SDRAM, 4MB Flash 10/100 BASE-TX (Cat. 5, RJ-45) Ethernet Interface REGULATORY / COMPLIANCE INFORMATION FCC Part 15.247, IC RS210, CE YES RADIO OPERATING FREQUENCY 5.475-5.825GHz TX SPECIFICATIONS Avg.Power 24 dBm 24 dBm 24 dBm 24 dBm 26 dBm 22 dBm 21 dBm 19 dBm DataRate 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps Tolerance
+/-1.5dB
+/-1.5dB
+/-1.5dB
+/-1.5dB
+/-1.5dB
+/-1.5dB
+/-1.5dB
+/-1.5dB M D F O a 1 1
. 2 0 8 RX SPECIFICATIONS Sensitivity
-94 dBm
-93 dBm
-91 dBm
-90 dBm
-86 dBm
-83 dBm
-77 dBm
-74 dBm DataRate 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps Tolerance
+/-1.5dB
+/-1.5dB
+/-1.5dB
+/-1.5dB
+/-1.5dB
+/-1.5dB
+/-1.5dB
+/-1.5dB M D F O a 1 1
. 2 0 8 Outdoor (BaseStation Antenna Dependent):
RANGE PERFORMANCE ANTENNA Gain Polarization Polarization Selection 3dB Beamwidth Azimuth 14dBi Multi-Polarized Software Controlled 55 degrees VSWR Front to Back Ratio 3dB Beamwidth Elevation Over 10km 1.4:1 30dB+
18 degrees Azimuth Elevation PHYSICAL / ELECTRICAL / ENVIRONMENTAL Enclosure Size Weight Enclosure Characteristics Mounting Kit Max Power Consumption Power Supply Power Method Operating Temperature Operating Humidity Shock and Vibration 26.4 cm x 8 cm x 3cm 0.4kg Outdoor UV Stabalized Plastic Pole Mounting Kit included 5 Watts 12V, 1A (12 Watts). Supply and injector included Passive Power over Ethernet (pairs 4,5+; 7,8 return)
-20C to +70C 5 to 95% Condensing ETSI300-019-1.4 ADDITIONAL INFORMATION AND COMPLIANCE NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
!
Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This is a Point-to-Point CPE Wireless Device. www.ubnt.com