Packing List Camera Introduction Installing Battery Quick Start Guide Version 1.0.2 Camera 1 QSG 1 Power Cable 1 LED Indicator Lens Built-in Mic PIR Detector Photosensor Power Port SYNC Button Built-in Speaker Bracket 1 Positioning Map 1 Screw Package 1 Battery 1 Note:
Press the SYNC button to pair with the base station. Press and hold the SYNC button for 8 s to reset the camera. The pattern of the LED indicator is included in the following table. LED Indicator Status Off Green light on Green light flashing Green light quick flashing Green light stay on for 10 s, then off Red light stay on for 10 s, then off Red light stay on for 1 s, then off Device Status Sleeping mode Run out of battery Alarm is triggered Instructed to wake Reconnecting Wi-Fi Waiting for pairing with the base station Pairing succeeded Pairing timeout Reset completed Safety Instructions
- Do not short circuit the battery with other metal.
- Do not heat the battery or throw it into fire.
- Do not take apart the battery or press it to make it deformed.
- Keep the battery away from children.
- It is recommended to use the original battery.
- Do not use the battery at temperature above 60/140.
- The battery cannot be charged at temperature below 0/32.
- Recycle the waste battery as local regulations instructed. About the Guide
-
-
-
This quick start guide is for reference only. Minor difference might be found in user interface. All the design and software here are subject to change without prior written notice. All trademarks and registered trademarks mentioned are the properties of their respective owners. Please visit our website or contact your local service engineer for more information. If there is any uncertainty or controversy, please refer to our final explanation. Pairing with the base station Step 1 On the base station: Press the SYNC button, and then the indicator on the base station flashes with white light. Step 2 On the camera: Press the SYNC button, and then the indicator on the camera flashes with green light. Step 3 The pairing starts, and the indicators flash as described below:
The system indicator on the base station stays on with white light for 10 s, and then off. The indicator on the camera stays on with green light for 10 s, and then off. The pairing succeeded then. Installing Camera Note:
Make sure the mounting surface is strong enough to hold at least three times of the device weight. Mounting Surface Self-tapping Screw Bracket Bracket Expansion Bolt Note:
You can pair six cameras at most with one base station, and pair one camera at a time. Keep the distance of the base station and the camera within 30 cm (12 inches) during pairing. Step1 Drill screw holes on the mounting surface as the positioning map shows, and then put in the expansion bolts. Step2 Open the bracket, and then attach the bottom of the bracket to the mounting surface with the self-tapping screws. Step3 Attach the other half of the bracket to the camera, then adjust the lens to the ideal angle, and then fix the bracket. This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body.