59303-C Gateway Ultra Client User manual

STEP 7 TROUBLESHOOTING Steady Red or Blinking Red: Spa is Not Connected. Blinking Blue: Remote Software Update is underway. Do not unplug power. Blinking Green: CMS Gateway Ultra Spa and Home Side Module RF is connected, but no connection to Internet. Steady Green: Spa Successfully Connected to Internet. No Errors. Problem No bluetooth signal detected in Step 6 Potential Solution Turn the spa power OFF, wait 10 Seconds, and then turn back ON Explanation The spas bluetooth signal is only Active and detectable for 20 minutes after the spas power is turned ON. FCC STATEMENT 15.19 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired operation. 15.21 Note: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the users authority to operate the equipment. CE STATEMENT Operating temperature: 25C Max RF Power level: 2mW BLE(2402-2480MHz): 3dBm 15.105(B) NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or tele-

vision reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the

- Consult the dealer or an experienced radio/TV technician for help. receiver is connected. IC STATEMENT This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interfer-

ence, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes:

(1) lappareil ne doit pas produire de brouillage, et

(2) lutilisateur de lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. RF Exposure information: The IERP power of the device as maximal case is below the exempt condition, 20mW specified in EN62479: 2010. RF Exposure assessment has been performed to prove that this unit will not generate the harmful EM emission above the reference level as specified in EC Council CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT Recommendation (199/519/EC). DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. TYPE. Hereby, Balboa Water Group LLC. Declares that the radio equipment type

(SD30001M/SD3001C) is in compliance with Directive 2014/53/EU. 3030 Airway Avenue | Costa Mesa, CA 92626 2019 Balboa Water Group. Single Source Solution. All rights reserved. Specifications subject to change without notice. 42346 QUICK START GUIDE GW ULTRA HOME MODULE WWW.BALBOAWATER.COM CONTROLMYSPA GATEWAY ULTRA QUICK START GUIDE HOME MODULE STEP 1 & 2 ETHERNET CABLE AND POWER SUPPLY 1 2 STEP 5 DOWNLOAD THE CONTROLMYSPA APP STEP 6 OPEN APP AND PRESS SETUP FOLLOW INSTRUCTIONS IN THE APP TO SETUP AN ACCOUNT STEP 3 & 4 STAND NEXT TO YOUR SPA AND ENSURE THE POWER IS ON Plug in the supplied Ethernet cable to a home router. And then plug the other end of the Ethernet cable into the CMS Gateway Ultra Home Module. 3 4 Plug in the supplied power supply to wall power. And then plug in the power supply into the CMS Gateway Ultra Home Module micro USB power port. Stand next to your spa (Within 10 feet/3 meters). RF Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. IC 20cm RF This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. Cet quipement est conforme aux limites dexposition aux rayonnements de la IC tablies pour un environnement non contr. Cet quipement doit tre install et fonctionner au moins 20 cm de distance dun radiateur ou de votre corps.