M/N: 53846-DI
Brief introduction:
(1) Wireless Charging Position
(2) Indication LED light
(3) Micro USB Input
(4) USB Output 1
(5) USB Output 2
Specification:
Wireless Distance: 8mm
Efficiency: ≥75%
Wireless Charger Input: 5V/3A, 9V/2A
Wireless Charger Output(Max): 10W (Compatible with 5W or 7.5W)
Dimensions: 123*75*94mm
Weight: 116g
Use Operation:
Charge other device
(a) Use a suitable cable to connect the Wireless Charger Stand
(*Remarks: This wireless charger stand is suitable for 10W fast charge, need to connect
to a Fast Charge power like 9V/2A)
(b) Put a Smartphone which is with Qi wireless charge function on the wireless charger
stand, make sure its position is at the middle right position
(c) The 2 USB Ports can output to charge smartphone or other device as well.
FCC Statement
This device complies with part 15 and part 18 of the FCC Rules. Operation is Subject To the
following two conditions:
(1) This device may not cause harmful interference, and (2) this devicemust accept any
interference received, including interference that may cause undesired operation. Changes or
modifications not explicitly approved by the partyresponsible for compliance could void the
user's authority tooperate this equipment.
Note: this equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 and part 18 of the FCC Rules. These limits are designed to
providereasonable protection against harmful interference in a residential installation. This
equipment generates, uses and canradiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference toradio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged totry to correct the
interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
· Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. During the operation of device a distance of 15 cm surrounding the device and 20
cm above the top surface of the device must be respected.
This device complies with Part 18 of the FCC Rules. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
●Increase the separation between the equipment and any other radio device.
●Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.