FN00040 Smart key FOB User manual

3. Outline of Smart Key FOB Electronic Key is mainly used for locking or unlocking the doors of the vehicles. Electronic Key detects signals when it reaches the vicinity of vehicle, and sends signals using radio frequency. Also, Electronic Key sends a radio wave signal while a button is pushed. When the button is released, the radio wave signal is automatically off within 0.392 seconds. When the button is depressed continuously, Electronic Key sends a signal for a predetermined constant time. Subject for application Installation in vehicle Electronic Key 314.35 MHz Smart Key ECU Transmitter IC Control IC Receiver Micom Actuator LF Transmitter 134.2 kHz This product sends a signal when the following buttons are pushed. Unlock button for unlocking the doors. Panic button for Panic Alarm Lock button for locking the doors Trunk button for opening the trunk or back door. Electronic Key Product Outline Electronic Key is mainly used for locking or unlocking the doors of the vehicle. Electronic Key detects signals when it reaches the vicinity of vehicle, and sends signals using radio frequency. Also, Electronic Key sends a radio wave signal while a button is pushed. When the button is released, the radio wave signal is automatically off within 0.392 seconds. When the button is depressed continuously, Electronic Key sends a signal for a predetermined constant time. The receiver becomes active in response to signals from the transmitter. Product Description Product Type RF characteristic Nominal frequency Appearance 4-Button type Unit: mm FN00040 314.35MHz Oscillator frequency 18.370MH X-tal, PLL synthesizer Built-in type (Fixed) Antenna Button 4-Button type Lock Unlock Trunk Panic 3V DC Power Supply Nominal supply voltage Type of Battery One lithium battery Explanation document of mechanical key for Electronic Key FN00040 Key groove varies according to each key. The key used for testing has no groove on its surface, which we consider is a worst case. Mechanical key Mechanical key detached Mechanical key attached Presence or absence of mechanical key does not affect on the RF characteristics. FCC ID: CQOFN00040 FCC Part 15.19 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Part 15.21 Any changes or modifications (including the antennas) made to this device that are not expressly approved by the manufacturer may void the user's authority to operate the equipment. IC: 1151E-FN00040 This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement.