HY-PULSE HYPE Bass Bluetooth Speaker Users Manual

 

Dt) HYP =

BASS Operation Manual HY-PULSE FCC ID: 2AANZHY-PULSE BT ID: BO20865 Thank you for purchasing the Bass Bluetooth Speaker. Please read all instructions carefully before using and retain this manual for future use and reference. PACKAGE CONTENTS

* Bass Bluetooth Speaker

* USB Charging Cable

* 3.5mm AUX Cable

* Operation Manual aN

* LED lights flash to music

* Compatible with Bluetooth-enabled devices

* Builtin rechargeable battery

* Media & volume controls

* Two powerful 3W speakers SAFETY INSTRUCTIONS Keep the unit away from heat sources, direct sunlight, humidity, water and any other liquids. Do not operate the unit if it has been exposed to water, moisture or any other liquids to prevent against electric shock, explosion and/or injury to yourself and damage to sia U a Do not use the unit if it has been dropped or damaged in any way. Repairs to electrical equipment should only be performed by a qualified electrician. Improper repairs may place the user at serious risk. Do not puncture or horm the exterior surface of the product in any way. Keep the unit free from dust, lint, etc. Do not use this unit for anything other than its intended use or purpose. Doing so may damoge the device. This product is not a tay. Keep out of reach af children. Do not use the speaker at excessive levels as this may damage hearing. 1 Do not expose batteries, battery pack, or batteries to installed to excessive heat, such as direct sunlight, or open flame. tN yee 0 abY 1. Builtin Mic 2. Call/Play/Pouse 3, Next Song/ Volume Increase 4, LED Mode/LED Power 5. Previous Song/Volume Decrease 6, Micro USB Charge Port yee msalaav ey ala eel 8. LED Ught Indicator 9, ON/OFF power switch CHARGING THE SPEAKER The speaker comes with a builtin rechargeable battery. Before using it for the first time, we recommend you charge the battery fully. Only use the supplied USB cable to charge the speaker. Connect the USB cable to a computer USB port and the Micro USB plug to the charging jack of the Unit. The red LED light wil illuminate while the speakers are charging. A full charge of the battery takes up to 3 hours. When the battery is fully charged the red LED wil tum off. Disconnect the speakers at this point. The speakers will then be ready for use. TURNING SPEAKERS ON/OFF Power On: Move the power switch into the ON position. Power Off: Move the power switch into the OFF position. PAIRING THE SPEAKERS 1, Ensure the speaker is tumed off. If they are not, pleose tum off the speaker first before pairing. 2, Move the power switch into the ON position and the device will then beep. This will indicate your speaker is now in pairing mode. 3. Place the speaker and the Bluetooth device to which you would like to pair it within the aperating distance. We recommend keeping the two devices no further than 33 feet apart. 4, Ensure Bluetooth is enabled on your phone or music device. Refer to the manufacturer's instructions for how to enoble Bluetooth on your device. 5. Once you have octivated Bluetooth on your device, select the HY-PULSE from the list of available Bluetooth devices. 6. If pairing is unsuccessful, turn off the speaker first and repair following the aforementioned steps. Once you have paired the speaker with a device, the earphones wil remember this device and will pair automatically when the device's Bluetooth is activated and in range. You do not need to re-pair ony previously connected fol oin LISTENING TO MUSIC Once the speaker is paired to your device, you can stream music wirelessly to the speakers. Select the track you wish to listen to on your device to listen via speaker. Should you encounter any problems while streaming, pleose refer to your devices user manual. USING A 3.5MM AUX CABLE 1, Using the included 3.5mm AUX cable, connect one end of the cable into the speakers 3.5mm AUX input. 2. Connect the other end into the 3.5mm input of the device you wish to play music from. 3. Move the power switch into the ON position. 4, Begin playing music from your connected device, previous song/next song function on speaker may not work in this mode. MANUAL KEY FUNCTIONS The speaker is equipped with a few shortcut keys. Please note the following functions. 1. Increase Volume - Press hold the +/ > button 2. Decreose Volume - Press and hold the 1/-" button 3. Play/Pause - Press #1 button Mele (ele alae RMF ame 9 Ui Cl8]

5. Next Track - Press the "+/" button 6, Answering/Ending a cal press mi button SWITCH OR TURN OFF LED LIGHTS 1, By default pulse mode turns on when you tum on the speaker. This is when alll the lights pulse to the music at the same time. 2. To tum off the lights press and hold the LED button. 3. To tum the lights back on, press and hold the LED button. 4, To change to baunce mode press the LED button once. Press once again to retum to pulse mode. CARE AND MAINTENANCE

* Do not expose the speaker to liquid, moisture, or humidity to avoid darnage to the products intemal orev A Do not use abrasive cleaning solvents to clean the unit.

* Do not expose the headset to extrernely high or low ternperatures as this will shorten the life of the electronic device, destroy the battery, and/or distort certain plastic parts.

* Do not dispose of the speaker in fire as they may explode or combust,

* Do not expose the speaker to contact with sharp objects as this will cause scratches and damage.

* Do not let the speaker fall from high places, as doing so may damage the intemal circuitry.

* Do not attempt to disassemble the speaker in the event that the speaker do not function properly, retum it to the store where it was purchased. SPECIFICATIONS Bluetooth: 7A Sensitivi 750B Frequency: ifs Cay dara Operating Distance: Up to 33ft (10m) a loN A llaatey Up to 1.5 hours Speaker Power. Se wa Battery: Built-in Rechargeable 3.7V, 800MAN Charging Time: Up to 3 hours WARRANTY INFORMATION Tne condition of this warranty and our respansibilities under this warranty are as follows:

Suppllers warranty is non-transferable. And this waranty ls limited to the original purchaser only.

* You must be able to prove the date of original purchase of the unit with a dated receipt.

* The warranty Is not applicable if the product has been subject to physical abuse, Impraper Insfallation, modifica-

tion or repalr by unauthorized third party.

"The responsiblity of supplier's products shall be limited to the repair of replacement of the product as its sole discretion.

* Specifically exernpt from any warranty are limitec-ife consumable components subject to nammal wear and tear such as batteries, decorates and other accessories.

* A suppller will not take any responsibility if the failure of the unit has resuited from occident, abuse, misuse, or any unauthorized repair, modification or disassemble.

* Modificatian and repalr af the unit should be done by authorized and qualified service personnel, Center ar returned to the manufacturer.

"This warranty gives yau specific legal rights, and you may also have other rights which vary under local laws. The fallowing conditions comprise the requirements and scope of our waranty conditions and do not affect our legal and contractual warranty obligations. We affer a warranty on our products in accordance with the fallowing canditions:

1) Hype products are cavered by a 12 month warranty. We will resalve damages ar defects on Hype products free of charge within 12 months of the purchase date under the following worranty canditions. Far any damage ar defect determined later than 12 months after the purchase date, proof of a manufacturing fault must be submitted for repalr under warranty. 2) The warranty does not cover batteries and other parts, which are considered consumables, parts that break easily such as glass or plastic or defects bosed on normal wear and tear. There |s no warranty 6 obligation In the event of marginal differences compared to the target appearance and workman-

ship provided these have a negligible effect on the products fitness for use, in the event of damage caused by chemical or electrochemical effects, by water or generally from abnomal conattions. 3) The warranty will be performed In such a way that we shall decide whether to repalr the defective parts or to replace them with working parts free of charge. Hype? reserves the right to exchange the product fora replacement product of equal value if the product sent in cannot be repalred within a reasonable time or at a reasonable cost. Requests cannot be made for fepalrs to be caried out on site. Parts that have been replaced or exchanged become aur property. 4) The warranty claim does not apply if repairs or other work |s carried out by unautharized persons or if our products are equipped with additlanal parts or accessories that are not approved for our product. 5) Warranties that have been activated do not cause the waranty periad to be extended, nor da they trigger a new warranty period. The warranty period for any replacement parts Installed ends with the warranty period for the entire product. 6) Any other further claims are excluded, especialiy those for replacement due to damage caused fo the outside of the product, pravided tnere Is no abligatory legal llability. We therefore accept no liabllity for accidental, indirect or other cansequential damage af any kind, which leads to usoge restrictions, data loss, and lass of eamings ar interruption to business. Asserting a warranty clalm:

1) To make use of the warranty service for hardware Issues, yau must contact the Hype Service Center by email at support@dglusa.com 2) Hype? will try ta dlagnose ond solve your problem. If It ls determined that a warranty clalm exists, you will be given on RMA number (Retum Materiol Authorization) and will be asked to send the product to Hype. IMPORTANT: Hype will anly accept parcels that have an RMA number. Please observe the following when sending the product:

1) Send the product suttably packaged with cariage and insurance pald. Do not enclose any accessories with the product (cables, chargers, manuals, etc.) unless the Hype Service Center specifies otherw'se. 2) Mark the RMA number on the outside of the package In such a way that It Is visible and clearly legible. 3) You must enclose a copy of the sales slip as proof of purchase. 4) Once Hype* has received the product, It will meet its warranty obligations In accardance with the warranty conditions and will retum the product to the sender with carriage and Insurance pald. Service outside af warranty Hype can refuse any service clalm made that Is not covered by the warranty. If Hype agrees to pravide a service outside the warranty, the customer will be Involced for all repair and transpart costs. Hype will not accept any packages that have not first been approved by Hype by means of an RMA (Retum Material Authorization). Contact us with questions at:

Suppart@dglusa.com This equipment has been tested and found to comply with the limits fora Class B digital device, pursuant to part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occurina particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet ona circuit different from that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 af FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation. Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. such modifications could void the users authority to operate this equipment. Any Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device is measured RF output power is less than the SAR exclusion threshold value for human head and body . Therefore, SAR test is not necessary.