Shenzhen Lingdong Intelligent Technology Co., Ltd TD01 Customer:
Sample NameBluetooth Music&APP Sample NumberTD01 Signature DATE TESTED BY CHECKED BY APPROVED BY MARK WELL JIAN Customer Signature TESTED BY CHECKED BY APPROVED BY PCB 69.0mm*35.0mm*1.6mm Top layer Speaker 2.0mm X2 Bottom layer Function 1BLE APP 2Bluetooth Music 3Mono Output Port specification Power input 36VPower Input GNDPower Ground RXUART TX Input Speaker :Speaker Output BLE UART Port:
GNDUART Ground BLE_RXUART RX BLE_TXUART TX RGB LED Port:
BBlue light signal output GGreen light signal output RRed light signal output 5V5V Power Output Product specification Input voltage range:
Hardware version:
Speaker Spec:
Operating Ambient Temperature:
Frequency:
12V42.5V V4.0(APP)+V4.2MUSIC 4 3W2 5W
-20 ~ +80 2.402GHz~2.480GHz FCC Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.