submitted | available | document details (if available) | source link |
---|---|---|---|
August 11 2016 | October 11 2016 |
various | Module Approval Request | Cover Letter(s) | 635.79 KiB | August 11 2016 / October 11 2016 |
telefication iai Modular A FCC ID: XHM-PB63D31 RF_734_02 04 April 16 roval Request FCC (KDB 996369 DO1 & Part 15.212) Items to be covered by Single modular transmitters. Answer from applicant 1. The modular transmitter must have its own RF shielding. Yes, The EUT provides the RF shielding. 2. The modular transmitter must have buffered modulation/data inputs (if such inputs | The EUT has its buffered are provided) to ensure that the module will comply with Part 15 requirements | modulation. Please see the under conditions of excessive data rates or over-modulation. Schematic Diagram. 3. The modular transmitter must have its own power supply regulation. The EUT has its own power supply regulation. Please see the Schematic Diagram. 4. The modular transmitter must comply with the antenna requirements of Section | The EUT meets the FCC 15.203 and 15.204(b)(c). The antenna must either be permanently attached or | antenna requirements; unique employ a unique antenna coupler (at all connections between the module and the | antenna connector and photo antenna, including the cable). of antenna are shown in the test report. 5. The modular transmitter must be tested in a stand-alone configuration, i.e., the The EUT was testes in a stand-
module must not be inside another device during testing. This is intended to alone configuration. Please see demonstrate that the module is capable of complying with Part 15 emission limits section photographs of test regardless of the device into which it is eventually installed. configuration in the test report. 6. The modular transmitter must be equipped with either a permanently affixed label | Please see exhibition label or must be capable of electronically displaying its FCC identification number in | sample for the FCC ID of this accordance with 15.212 (a)(1)(vi)(A) / (B). module. And also in the exhibition Users manual, there are instructions gives to the OEM on how to label the end product 7. The modular transmitter must comply with any specific rule or operating | The EUT is compliant with all requirements applicable to the transmitter and the manufacturer must provide | applicable FCC rules. Details adequate instructions along with the module to explain any such requirements. A | instructions for maintaining copy of these instructions must be included in the application for equipment | compliance are given in the authorization. For example, there are very strict operational and timing | User Manual. requirements that must be met before a transmitter is authorized for operation under Section 15.231. For instance, data transmission is prohibited, except for operation under Section 15.231(e), in which case there are separate field strength level and timing requirements. Compliance with these requirements must be assured. 8. The modular transmitter must comply with any applicable RF exposure The EUT is compliant with RF requirements. For example, FCC Rules in Sections 1.1310, 2.1091, 2.1093, and | exposure requirement. RF specific Sections of Part 15, including 15.319(i), 15.407(f), 15.253(f) and exposure is addressed in the 15.255(g), require that Unlicensed PCS, UNII and millimeter wave devices RF exposure exhibition. perform routine environmental evaluation for RF Exposure to demonstrate compliance. In addition, spread spectrum transmitters operating under Section 15.247 are required to address RF Exposure compliance. Modular transmitters approved under other Sections of Part 15, when necessary, may also need to address certain RF Exposure concerns, typically by providing specific installation and operating instructions for users, installers and other interested parties to ensure compliance. Note: A limited modular approval (LMA) may be granted for single or split modular transmitters that comply partially with the requirements above. Name and surname of applicant (or authorized representative): Avin / Manager telefication RF_734_02 z- 04 April 16 Date: Oct. 3, 2016 Signature: Wu Z
This product uses the FCC Data API but is not endorsed or certified by the FCC