Slim 418MHz Transmitter Model #: SLIM418TX Operation o To dial Emergency Line:
Learning-in the Slim Transmitter Press the Emergency button, a radio signal will be transmitted to the Control Panel. Please refer to the learn-in procedure of your Control Panel for further instruction. Press and release the Transmitter button, the GREEN LED will illuminate for .5 seconds and transmit the message to the Control Panel. o Sleep Mode:
-The Transmitter ships in Sleep Mode to conserve battery life
-Pressing the Emergency Button once will cause the Transmitter to exit Sleep Mode Battery & Electrical Specifications o o o o Open Field Range: 350 ft o Frequency: 418 MHz Battery: CR1632, 3V 130mAh Battery life: Typical life expectancy of 3 yrs at an average use rate of one activation per day. Low battery status: when the battery voltage is below the threshold, the Transmitter will indicate a low battery by illuminating the RED LED for .5 seconds when the Emergency button is pressed. The low battery signal will be transmitted to the Control Panel. A supervisory message will be sent during a low battery state once every 6 hours. FCC Statement FCC Caution This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance may void the users authority to operate his equipment. (Example use only shielded interface cables when connecting to computer or peripheral devices) FCC Section 15.105 Information to the user. NOTE:
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. FCC ID: XO8-SLIM418TX rev. A01