Federal Communications Commission Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 Company name: Silver Spring Networks FCC ID: OWS-MIL51 Gentlemen, In accordance with 47CFR 15.212 Modular Transmitters and KDB 996369 D01 Module Certification Guide v01r04. FCC ID: OWS-MIL51 has been examined against the following requirements. Requirement per 15.212 and KDB 996369 D01 Modular Certification Guide v01r04 The radio elements must have the radio frequency circuitry shielded. Physical components and tuning capacitor(s) may be located external to the shield, but must be on the module assembly The module must have buffered modulation/data inputs to ensure that the device will comply with Part 15 requirements with any type of input signal The module must contain power supply regulation on the module Explanation from Grantee
(do not write yes/no, but explain why product complies/how it is achieved) A stainless steel shield completely covers the module including radio elements. The Milli 5 does not have any external modulation inputs. Power supply regulation must be supplied by host device and must follow guidelines specified in User Manual. The module must contain a permanently attached antenna, or contain a unique antenna connector, and be marketed and operated only with specific antenna(s), per Sections 15.203, 15.204(b), 15.204(c), 15.212(a), 2.929(b) The module does not contain a permanently attached antenna, nor a unique antenna connector. 50 ohm PCB Design guidelines are provided within the User Manual. The module must demonstrate compliance in a stand-alone configuration The module must be labelled with its permanently affixed FCC ID label, or use an electronic display (See KDB Publication 784748 about labelling requirements) The module must comply with all specific rules applicable to the transmitter including all the conditions provided in the integration instructions by the grantee The module must comply with RF exposure requirements The module was tested on HDK (Hardware Development Kit, SSN PN 174-0768-00) that provides circuitry representative of a typical host system. HDK includes regulated power, buffered data inputs, a 50 ohm co-planar waveguide and external antenna connector. FCC ID label is present on the module. The module complies with all the requirements of 15.212(a)(1) modular rules only when constrained to specific operating host(s) as specified in the User Manual. Please refer to the MPE test report. Max gain antenna allowed on this device is 3 dBi. Silver Spring Networks, Inc. 230 West Tasman Drive San Jose, California 95134 T +1 669 770 4000 ssni.com Name: Asim Tirmizi Title: Manager HWQA Signature of applicant Date: December 16, 2016 Silver Spring Networks, Inc. 230 West Tasman Drive San Jose, California 95134 T +1 669 770 4000 ssni.com