READYGW1 READy Gateway UserMan Users Manual

READY Gateway - Technical data 3-wire RS485, using MODBUS protocol Optical eye Technical data Communication interface Meter reading READy Gateway configuration Data transfer to smartphone/tablet Wireless M-Bus, C-mode according to Data transfer to concentrator Further interfaces User interface Frequency Wireless M-Bus, C-mode EN13757-4:2013 Wireless M-Bus, C-mode, according to EN13757-4:2013 Optical eye (reading out log data) Display 912.5/915.0/918.5 MHz Mechanical data READy Gateway LxWxD (inches) Weight incl. bracket (oz) IP protection class 4.8 x 3.5 x 3.5 23.3 IP68 Bracket for READy Gateway LxWxD (inches) Weight (oz) 3.9 x 2.4 x 3.3 3.2 Temperature range Operation Storage Flooding temperature Power supply Internal battery supply Battery lifetime Markings/Standards FCC ID: OUY-READYGW1 RoHS FCC part 15B

-4 - +140 F

-40 - +158 F

+35.6 - +140 F 2 x D-cell batteries (3.6 VDC) 6 years Safety information/Disposal Do not expose READy Gateway to open fire. Do not short circuit the connector on READy Gateway. Please return READy Gateway to Kamstrup if the above specifications cannot be fulfilled. Maintenance The READY gateway must always be properly assembled when cleaning is carried out in order to protect the internal parts of the meter. Use only water when cleaning. Activities including installation, adjustments, putting into service, use, assembly, disassembly and maintenance are required to be carried out by suitably trained personnel in accordance with applicable code of practice. If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be impaired. READY Gateway - Technical data Battery replacement When you need to replace the batteries you must always use the proper battery replacement kit supplied from Kamstrup. See details for replacement in the manual delivered with the battery replacement kit. Caution: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. During battery replacement, keep battery dry at all time and dispose used batteries according to regulations. The battery voltage is 3.67 V maximum, provided by 2 D-cell (Kamstrup part number 1606064). Minimum operational battery voltage : 3.0 V. A lower voltage is detected as battery low condition. Operation for 24 hours with a low battery condition will be reported by an alarm and is an indication that battery replacement is required. Below 2.7 V the device will cease normal operation and be kept in power down. FCC Cautions Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with Part 15 of the FCC rules.Operation is subject to the following 2 conditions:1. This device may not cause harmful interference, and2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by tuning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the Increase the separation between the equipment and receiver receiver is connected Consult the dealer or an experienced radio/TV technician for help Order information Top number:

Type number:

Accessories READy Converter (Walk-by/Drive-by solution) READy Concentrator (Fixed network solution) Battery replacement pack READyGateway 6696XXXXXXXX READyConverterI READyConcentratorI 6699 031 Do not dispose the appliance in the trashcan, but according to the regulations Technical assistance Technical assistance may be obtained from Kamstrup Industrivej 28 DK-8660 Skanderborg Please visit Kamstrup website for the nearest local representative kamstrup.com/en-en/contact

. 5 1 0 2 2 1 _ S U _ 1 B _ 1 6 7 1 2 1 5 5 S

/

A p u r t s m a K