submitted | available | document details (if available) | source link |
---|---|---|---|
July 20 2019 | July 20 2019 | www.ilovepdf.com |
various | User Manual | Users Manual | 2.44 MiB | July 20 2019 |
How To Bind 4. Turn on the Vehicle. 2. Hold the Signal Match Button for around 4 second then the Transmitter signal light will flash for 6-7 second 3. After the wheels of the Vehicle turn left and right and the LED light of the Transmitter stops flashing, the binding process completed for playing 4. IFit cannot complete within 8 seconds, please tum off the Vehicle and re-start the binding process. 5. When the binding process is done, whenever switching the Vehicle on and off, it searches for the code that it memorized, and will only lock on to the Transmitter signal containing that code. 6. Please turn off the Vehicle and re-start all binding process if changing to another 2.4GHz Transmitter for playing. ow Play 1, Switch ON the Vehicle 4, Play on smooth surface to have the optimum performance 5, Remember to switch OFF the power of the Vehicle after playing 6. The optimum control range is up to 20m outdoor Performance Tips Do not drive on grass, dirt, sand, dusts, carpet or go through water. Do not drive in windy or rainy weather. Avoid direct impact the Vehicle with obstacles Switch OFF the power when not in use to prevent damage of Vehicle and Transmitter due to leakage of electrolyte from batteries. Remove all batteries from the Vehicle and Transmitter when not in use for long period. Keep fingers, hair and loose clothing away from wheels. The operating range can be affected by a variety of factors a) Low Voltage of batteries in Transmitter or Vehicle b) Interference from other items that emit radio frequency signals. Outdoor usage is recommended in order to get optimum control range. Recommend to play the vehicle on a clean and smooth surface. Clean the battery compartment to make sure it is free from dust to prevent poor per TTD Decne ee ecu Ne aC Re Pa ete cd ean est et Ces tu Rena eee ec ne]
Meum Re ho]
Tn ay Teun Weel Soe cera tuite Cann une Ree ume Cua ena eect) oat ieaeicicgtes Meni na Mh etc agen ume mae ea) ROE WER een tee eM cere arate tet eg Reo eau et ae contact of batteries FCC label compliance statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation, Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RSS-210 Compliance Statement:
This device complies contains licence-exempt transmitter that comply with Innovation Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference: and (2) This device must accept any interference, including interference that may cause undesired operation of the device Lmetteur exempt de licence contenu dans le prsent appareil est conforme aux CNR d'innovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) Lappareil ne doit pas produire de brouillage: (2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Declaration of Conformity The product is in conformity with the requirement of EU Directive 2014/53/EU Environmental notes: (Bucari) Official The whole product also does not belong to household waste at the end of the product life. z You can retum it at collection points for the recycling of electronic and electronical instruments C / Licensed The symbol on the item, instruction manual, hangtag or packing is showing this clearly, Materials should be recycled according to their respective markings Product Recyeling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection. Please ask at your local community for the correct collection point. pe Disposal of batteries Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries, You can hand in your old batteries CECO Conforms to the safety requirements of ASTM F963 KIDZTECH TOYS MANUFACTURING LTD. reed Room 802,/F, Inter-Continental Plaza, 2 94 Granville Road, TST East, Hong Kong, i Tel: (852) 27218868 info@kidztech.net Made in China http:/lwww-kidztech.net at public collection points in your area or wherever batteries are sold, You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:
Pb=Battery contains lead es attery contains cadmium attery contains mercury swwikldtech.net errr
This product uses the FCC Data API but is not endorsed or certified by the FCC