Wireless Controller Model:SMWireless FCC ID:2AEYKSMWIRELESS Technical specification Model:
SMWireless Transmit mode wireless ASK transmit Quiescent current 0.1uA Operating current :
10mA Power supply:
12V/DC Operating voltage:
9V-12.5V Oscillation mode:
SAW resonance Modulation mode:
ASK The spec Ground experiment:
three times, remote control electric property without exception and shell Remote control without packaging , free from 60 cm above the ground without damage Transmitting power 50M(use with GD-RD5 directivit 360 Operating frequency:
433.92MHZ requency er 75KHZ(MAX) Description Size:
Key 52*40*13mm) 4KEYS Power 12V/27A*1 Material plastic Color Plastic Key pressure Storage temperature 180 40g 10 - 60 Ambient humidity 60%-90%(RH) Buttons used times More than PET 10times Approval standards:
Products good /bad :
ISO9001:2000 FCC Best Quality Picture NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)thisdevicemaynotcauseharmfulinterference,and
(2) this device must accept any interference received, including interference that may cause undesiredoperation. Changes or modifications to this unit not expressly approved by the party responsible for compliancecouldvoidtheuser'sauthoritytooperatetheequipment. The device meets RF Exposure requirements without any restriction.