MP38542 Bluetooth Earphones User Manual

FCC ID: 2ADDH-MP38542 NOTE : Please tear the stickers underneath the earphones before using. Turn on the left and right earphones by pressing and holding the MFB on both earphones for about 1 second . The earphones will automatically enter pairing mode . Search the list of available Bluetooth devices for the name TWEPlus, then select it to connect . The earphones will give the following voice prompts:

Power on Pairing (Right earphone) Connect (Right earphone) Power O 1. Put the earphones into the charging box , it will power o automatically and the white LED will light up means the earphones are charging. If you put either one earphone into the charging box separately , the other one will automatically enter pairing mode. 2.When the earphone is on , press and hold the MFB for 4 seconds. Power On and Pairing the Single Earphone 1.After pairing both earphones , if you put the left earphone back into the charging box for charging , the right earphone will still connect with your device. If the left earphone full charged , you take it out of charging box , it will connect with the right earphone automatically , then two earphones are back to stereo sound. 2.After pairing both earphones , if you put the right earphone back to the charging box for charging , the left earphone will stop playing and enter pairing mode with voice prompt Pairing . The pairing name is still TWEPlus in your device , please select to connect. Then there is voice prompt Connected . Once paired, you can wirelessly stream audio from your device to your earphones. Music will automatically pause when you receive an incoming phone call and will resume once the call has ended. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference This device must accept any interference received, including interference that may cause undesired operation.