INSTRUCTIONS FOR OPERATION SETING THE OPERATING CONTROLS 1. This unit operates on a 1.5 volts battery *2 (not included). To prevent possible damage if the battery should leak , be sure to remove the battery when the unit is not use . 2. 3. Store the controller away from excess heat or humidity . This remote control unit is required with 26bit code combinations. To prevent possible interference from or to other remote units such as garage door openers, car alarm or security system . 4. Operation buttons on the panel of transmitter . button - FAN ON/OFF button increases the fan speed button decreases fan speed button Start up/shut down natural wind mode button Start up/shut timer button Fan reverse Warm weather button Fan reverse Cool weather button - Light ON/OFF button - Decrease the desired light level button - Increase desired light level 910805 1 CONTROL SWITCH For light brightness and ON/OFF control . 5. Start the fan or Turn off the fan Press the FAN ON/OFF button
. 6. Fan speed control :
Press the , button to run the fan at the desired. 7. Light control :
Turn the light on or off : Press the LIGHT ON/OFF button . Dimmer : press the Decrease the desired light level button , or press the Increase desired light level button. GENERAL INFORMATION :
This REMOTE controller is designed to separately control your ceiling fan speed and light brightness . The Light ON/OFF button will control the light brightness ON/OFF . The LED indicator on the transmitter will light when the Function button is pressed . INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED CONTROLLER 1. Setting the code on your new transmitter . Within 60 seconds of turning the AC power on, press and hole the FAN ON/OFF button for 5 seconds. The receiver will then lock in the chosen frequency. If your fan has a light it it will blink twice, for fans without lights check operation using the transmitter NOTICE :
The changes or modifications not expressly approved by the party responsible for compliance could void users authority to operate the equipment . This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause 910805 2