SE681 WiMAX / multi / 253421951 / Sec_FCC_ACTA_681.fm / 8.11.11 Installation and Safe Usage Instructions Federal Communications Commission (FCC) Statements This device complies with Part 15 of the FCC Rules. Operation is subject to the follow-
ing two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. Radio Frequency Interference Statement 7 0 _ 4 0 _ 1 1 0 2 l e n o b a h c S Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the fol-
lowing measures:
1. Reorient or relocate the receiving antenna. 2. 3. Connect the equipment into an outlet on a circuit different from that to which the re-
Increase the separation between the equipment and receiver. ceiver is connected. 4. Consult the dealer or an experienced radio/TV technician for help. Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncon-
trolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The installation of the base unit should allow at least 8 inches between the base and persons to be in compliance with FCC RF exposure guidelines. Modifications You are cautioned that charges or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. 97