| submitted | available | document details (if available) | source link |
|---|---|---|---|
| various | Users Manual | Users Manual | 141.13 KiB |
Keypad & Proximity Flash Mount Reader Installation Manual Mounting:
1. Install the metal plate on the wall with two or four screws, which depends on different kinds of gang box being installed1. 2. The cover shall clip on the upper edge 2 the push in the bottom part as show in Recommendation:
1. Linear DC Power Supply;
2. 22AWG shielded cable; its required to do one-point ground. (As shown in the diagram) diagram3. 3. Tighten the secure non-dropout screw, which located underneath of the reader to fix the reader and the back plate4, installation is completed. Specification:
Input Voltage (at Reader end) DC10V~15V Operating Current 160mA (max) Operating Temperature Power up Sequences:
-30C~70 C Typical Read range Maximum Cable Length Number pad format
> 5cm 150m 4 bits burst by default Description Power Supply to the reader Signal GND Wiegand Output data, D0 Wiegand Output data, D1 RED LED control, active low. Green LED control, active low Buzzer input, active low Tamper output (open collector, Active low, max 100mA) Color Red Black Green White Yellow Blue Brown Orange Label
+12V dc GND Data0 Data1 RED LED Green LED Buzzer Tamper Wiring:
1. When reader is powered up, the Green back will flicker for 5 seconds. The reader will beep once and the reader is in Ready mode. 2. Present the card. The Blue LED will flicker once; buzzer will beep once. 3. When card is present and read by the reader, blue back lit will flash once; and buzzer will beep once as well. The card data will then transmit to the controller. After, weather the back lit of the reader will remain ON or Flash or change to Green or Red color, this shall depend on the Green and Red LED inputs. 4. For number pad reader, when a number is pressed and successfully detected, the back lit under the number will flash 1 time and the buzzer will beep once. The number being pressed will burst out by default (4 bits burst). Physical Dimension:
Keypad & Proximity Flash Mount Reader Installation Manual FCCWarning:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Troubleshooting:
Trouble List No Response when Power Up Solution
Discount the power and confirm that the power supply cable is correctly connected (See Wiring above).
Check the input voltage is sufficient (See Specifications above). Auto Restart
Check the input voltage is sufficient (See Specifications above).
Check the format setting on the controller if it is the same as the card Cannot read card number correctly format. Use approved card (known format and Facility Code) to test.
Check if the shield cable is correctly connected to Classis Ground at ONE point only.
Check if data 0 & data 1 cable is correctly connected (See Wiring Reader beeps but No card data info above).
Check the input voltage at the card reader end is correct (See Specifications above). Buzzer error
Check if the buzzer cable is correctly connected (See Wiring above). Back Lit Error
Check the Led cable is correctly connected (See Wiring above).
Use Default Configuration Card to set it back to normal.
This product uses the FCC Data API but is not endorsed or certified by the FCC