Sichuan AI-Link Technology Co., Ltd. Federal Communications Commission Equipment Authorization Division 7435 Oakland Mills Road Columbia, MD 21046 USA Date: 2019-12-10 Subject: Modular Transmitter Application Company name: Sichuan AI-Link Technology Co., Ltd. FCC ID: 2AOKI-WFM68AUWF1 Dear Sir/Madam, This letter includes the FCC application requirements for Modular Transmitter Approval Request for;-
FCC KDB 996369 D01 Module Certification Guide v02; and FCC KDB 996369 D03 OEM Manual v01 In accordance with 47CFR 15.212 Modular Transmitters and KDB 996369 D01 Module Equip Auth Guide v02. FCC ID: 2AOKI-WFM68AUWF1 has been examined against the following requirements. Requirement per 15.212 and KDB 996369 D01 The radio elements must have the radio frequency circuitry shielded. Physical components and tuning capacitor(s) may be located external to the shield, but must be on the module assembly. The module must have buffered modulation/data inputs to ensure that the device will comply with Part 15 requirements with any type of input signal. The module must contain power supply regulation on the module. Explanation from Grantee
(do not write yes/no, but explain why product complies/how it is achieved) The modular have RF own shielding The modular transmitter have buffered modulation/data inputs The modular transmitter have its own power supply regulation. The module must contain a permanently attached antenna, or contain a unique antenna connector, and be marketed and operated only with specific antenna(s), per 15.203, 15.204(b), 15.204(c), 15.212(a), 2.929(b). The module must demonstrate compliance in a stand-alone configuration. Device is equipped with one PCB antenna and two internal antennas The module compliance in a stand-alone configuration. The module must be labeled with its permanently affixed FCC ID label, or use an electronic display (see KDB Publication 784748). The module must comply with all specific rules applicable to the transmitter, including all the conditions provided in the integration instructions by the grantee. The module must comply with RF exposure requirements The FCC identification number can put on the modular with either a permanently affixed label The instructions will be provided and apply to a complete transmitter and comply with specific rule. The total power density of modular transmitter final configuration comply with FCC RF Exposure FCC Modular Approval Request Rev 3.0 Sichuan AI-Link Technology Co., Ltd. Integration Instructions for host product manufacturers The following items are submitted in support of application for Modular Transmitter FCC ID as noted above as required by the FCC KDB 996369 D03 OEM Manual v01. These items are provided as integration instructions for host product manufacturers (e.g., OEM instruction manual) to use when integrating a module in a host product. Any requirements that are not applicable to the Module are as indicated below. Summary of requirements and Checklist.Refer to the KDB for description of the complete requirements;
KDB Ref Sect Requirements of KDB 996369 D03 User Manual Page Number reference Page 7 Page 4 Not compliance Not compliance Page 7,8 Page 4 Page 8 Page 8 Page 8 2.2 2.3 2.4 2.5 2.6 2.7 2.8 2.9 2.10 List of applicable FCC rules Summarize the specific operational use conditions Limited module procedures Trace antenna designs RF exposure considerations Antennas Label and compliance information Information on test modes and additional testing requirements Additional testing, Part 15 Subpart B disclaimer Name: Caixia Hu Title: Engineer Date: 2019-12-10 Signature of applicant FCC Modular Approval Request Rev 3.0