BH09 Bluetooth Earphone User Manual

TT-BH10 specification 1 Outlooking parameter and instruction Button instruction:

1.Volume +

2.Multi-function 3. Volume -

4.LED 5.MIC 6.MICRO USB 1 2.Basic parameter Product size: 625*17*22mm Product weight18gbare Working voltage3.7 V Successive working time Around 5~6 hours Charging time1~2 hours Charging current80mA No connected will be power off automatically5 minutes Support 1pcs earbuds connect 2pcs smart phones Support APTX 3.1 Bluetooth Bluetooth chipset CSR8645A04 Bluetooth version 4.1 Profile RF A2DP AVRCP HSP HFP 2402~2480MHz Receiving distance 360 10meter 3.2 MIC MIC SPEC:3.7*2.2*1.1mm MEMS MIC Sensitivity-423dB 3.3 Battery Battery Spec3.7V 95mAh Battery size6.0 * 12 * 20mm Battery life300 times 3.4 Speaker Speaker OD14.2mm Speaker impedance32 Rated power10mW (Max power: 15mW) Frequency response1004.5KHz Sensitivity110dB3dB Speaker curve 2 4 Operation Power onPress and hold down the power button till a blue light appears Power offPress and hold down the power button till a red light appears Paring Press and hold down the power button 6~8 seconds till red and blue light flashing Volume adjust: Press and Hold down the volume + to increase volume or Volume - to decrease the volume Music track choosePress Volume - shortly to select previous track, and Volume + to select the next track. Pause/play: When the bluetooth headset is connected with mobile phone, press the power button once to play music, press power button quickly to pause the music. Answering/ending the callPress the power button once to answering or end the call Reject callingPress the power button 1~2 seconds Redialing a call: Press the power button twice to redial the last dialed phone number on your mobile phone. 5 LED instruction Charging Red LED when charing, after full charge, blue LED PairedBlue Led flashing slow ParingRed and blue LED flashing alternate 6. Voice reminder POWER On POWER OFf Connected Pairing 3 NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.