SC-904BTK Microphone Speaker user manuaL Users Manual

Karaoke Treasure Instructions NEXT PREV

.Buttons Operation 1. Hold:ON/OFF Press:Mode switching 2. Press:the previous song under Mp3 mode. Under selfiemode,pressit toenableselfiefunction

(only for iOSsystemmobilephone) 3. Press:the previous song under Mp3 mode. Under selfiemode,pressit toenableselfiefunction

(only forAndroid systemmobile phone) 4. Press:Play/Pause.Under FMstate,hold it tor automatic search 5. REC MIC/Replay Press:Mike ON/OFF Hold:Replay function under TF card playmode 6. 7. VOL+ Increasevolume VOL- Decreasevolume SCAN

.Wireless Karaoke 1.Supplypower:Hold 2.Wiress connection:enable the wirelessof mobile phone,clickto connect, buttontostarttheproduct. successful connection if prompt tone isproduced. 3.Adjust sound:adjust the soundvolumeof mikeandthereverberationtosuitable level. 4.Start Karaoke. Recording with mobile phone 1.Connect therecording wire:insert the MICROplugof therecordingwireinto the MICRO interface of KaraokeTreasure,andthe3.5mminterfaceintothemarphonejackof themobile phone. 2.Open the Karaoke soffware in the mobile phone,such as:USING,Kugou Musicor other recording APPs,select your favorable song,record the song according to the above mentioned singing method. 3.Test andsavethesong:operate accordingtotheinstructions of Karaokesoftware. buttontoswitchfromwirelessmodetoselfiemode. Selfie function 1.Pressthe 2.Enablewireless inthe mobilephone,search shutter 3.Openthephotographinterfaceofthemobilephone,pressthe Note.4.2.2or higher versionfor Androidsystem,6.0 or higher versionfor iOSsystem, it doesn t support other versions temporarily,itdoesn t the mobile. Phone which hasthe independent andsolid photograph button.

,clickcommection. or buttontotakephotos. Techmical Parameters FrequencyRange:100Hz-10KHz Output Power:5W Max SoundPressureLevel:>115dB 1KHz THD<1%

Reverberation Mode:sound effect reverberation Power Supply:Built-in 18650 Li-battery Battery Capacity:1200mAh Charging Power:DC5V Created with the free version of GreenCloud Printer FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Created with the free version of GreenCloud Printer