EYSLSN Bluetooth low energy / ANT Module Short-Term Confidential User Manual

18-Jul.2018 Ver.0.9 EYSLSN TAIYO YUDEN CO., LTD. User manual

(for EYSLSN) FCC ID: RYYEYSLSN IC Number: 4389B-EYSLSN TAIYO YUDEN CO., LTD. 1/3 18-Jul.2018 Ver.0.9 EYSLSN TAIYO YUDEN CO., LTD. Since this module is not sold to general end users directly, there is no user manual of module. For the details about this module, please refer to the specification sheet of module. This module should be installed in the host device according to the interface specification

(installation procedure). The following information must be indicated on the host device of this module;

1) Japan Regulatory Information a) This Product is a radio system and obtained certification of construction type combined with the specific antenna. b) Please ensure that your product has a label with the following certification mark at easily viewable location. If your product is too small to have the label, please place it in the instruction manual and package of your product. The mark diameter shall be equal or greater than 3mm. In case your product does not have the label with the following certification mark, you or your customer who uses your product may be against the Radio Law and subjected to criminal punishment. TAIYO YUDEN shall not be liable for any loss or damage incurred by you or your customer arising from use of your product which does not have following certification mark. This product has a radio system which was approved as a radio station in a low power data communication system based on the Radio Law. EYSLSN : 001-A 2) Canada Regulatory Information a) This device complies with Industry Canadas applicable licence-exempt RSSs. Operation is subject to the following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :

1) lappareil ne doit pas produire de brouillage;

2) lutilisateur de lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. b) This product is certified as type of the portable device with Industry Canada Rules. To maintain compliance with RF Exposure requirement,please use within specification of this product. Ce produit est certifi comme type de l'appareil portable avec Industrie Rgles de Canada. Pour maintenir l'acquiescement avec exigence Exposition de RF, veuillez utiliser dans spcification de ce produit.

- IC: 4389B-EYSLSN TAIYO YUDEN CO., LTD. 2/3 18-Jul.2018 Ver.0.9 EYSLSN TAIYO YUDEN CO., LTD. c) Please notify certified ID by either one of the following method on your product.

-Contains IC : 4389B-EYSLSN Specifiez ID certifie dans votre produit par une de mthode suivante.

-Contains IC : 4389B-EYSLSN 3) FCC Regulatory Information a) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. b) Please notify certified ID by either one of the following method on your product.

-Contains Transmitter Module FCC ID: RYYEYSLSN

-Contains FCC ID: RYYEYSLSN c) CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the uses authority to operate the equipment. d) This product is certified as type of the portable device with FCC Rules. To maintain compliance with RF Exposure requirement, please use within specification of this product. e) The antenna used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. f) This module can change the output power depending on the circumstances by the application software which is developed by module installer. Any end user cannot change the output power. 4) CE Regulatory Information a) When your end product installs this module, it is required to proceed additional certification processes before placing on the market in EU member states to make your products fully comply with relative EU standards. b) TAIYO YUDEN can provide you the test reports of conducted measurement portion for the radio module. You can utilize the test reports for the certification processes of your end product as it requires radio testing. TAIYO YUDEN CO., LTD. 3/3