KB8 Mobile Phone Quick Start Guide Users Manual

Explosion diagram Explosion diagram specification specification 1 3 5 7 9 11 13 15 17 19 21 23 25 TP+LCM MAIN PCBA REAR CAMERA BAT&TP_BTB STEEL UP FRAME LOWHOUSING REAR CAM LENS SPK FRAME BATTERY SIDEKEY FPC SUB PCBA SPK FPC AUDIO RUBBER 2 4 6 8 10 12 14 16 18 20 22 24 UPHOUSING CARD HOLDER FRONT CAMERA REAR CAM DECO SCREW BATTERY COVER SCREW FP USB RUBBER MAIN FPC CABLE LINE EASY PULL AD Know your phone 1 1. Front camera 2. Volume key 3. Power key SIM/SD card installation Power offoff mobile. 1.1. Power mobile. Refer toto thethe following 2.2. Refer following picture picture forfor SIMSIM // SDSD cardcard installation. installation. Charging the phone your device device using YouYou cancan charge toto thethe computer using aa USBUSB cable 1.1. Please Please remind 2.2. UseUse onlyonly TECNO charge your computer using remind thethe front TECNO charger damage thethe device. maymay damage warranty. warranty. using aa charger cable (comes charger oror byby connecting connecting itit

(comes withwith thethe phone). phone). front andand backback ofof thethe plug. plug. charger andand cables. cables. Other device. ThisThis willwill invalidate invalidate your chargers oror cables cables your phone phone Other chargers FCC Caution Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to following two conditions:(1)This device may not cause harmful interference and (2) this device must accept any interference reveived, including interference that may cause undersired operation. Information to user. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against installation. This equipment harmful generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help. interference in a residential Specific Absorption Rate (SAR) information:

This mobile phone meets the government's requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6W/kg averaged over one gram of tissue. Device types:KB8(FCC ID:

2ADYY-KB8)has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 1.19W/kg and when properly worn on the body is 0.33W/kg. This device was tested for typical body-worn operations with the back of the handset kept 10mm from the body. RF exposure requirements, use accessories that maintain a 10mm separation distance between the user's body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that does not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided. To maintain compliance with FCC