RTO OS PAYME ENT DEVICE E RP-1 10 INST TALLATIO ON GUIDE E d 1. PACKAGE CONTENT 2. DEVICE OVERVIEW
RP-10
Privacy Shield
(Optional) RP10KeyButtons&InterfacePorts(Figure1):
FRONT REAR FRONTAREA Figure1 1 2 2.4 Display Rubber Keypad REARAREA 3 Magnetic Strip Reader (MSR) slot 4 5 6 Smart Card Reader (SCR) slot USB cable (type A) Battery Compartment RP-10 power spec:
Input:5VDC,0.5A
OperatingTemperature:0oCto40oC 3. POWER ON/OFF THE DEVICE Topoweronthedevice,pleaseplugtheUSBcableintotheUSBportofyourhostterminalor POS. Note:WhenthereisnoactiononRP10after60seconds,thedevicewillenterpowersaving mode.Pleaseshortpressanybuttononkeypadtowakeupthedevice. 4. USING THE MAGNETIC CARD READER Swipe the card through the slot with magnetic stripe side facing the same direction as the display.(Figure3) Figure3 5. USING THE IC CARD READER Insert an IC card into the slot (Figure 4) with the chip side facing the same direction as the touchpanel(Figure5). Figure4 Figure5 6. USING THE KEY PAD Afterinsertingthechipcard,Pressthenumerickeyasbelowkeypad(Figure6)toenterthe desirablenumbers.PressCancel(X)keytoterminateanycurrentfunctionandpresstheEnter
(O)keytoconfirmavalueoranoption. Figure6 7. USING THE CONTACTLESS CARD READER Tapthecontactlesscardontopofthecontactlesslogo(Figure7). Figure7 9. INSERT SIM & SAM CARD Afterremovingthebatterycover,theusercanfindSAM*2slotsatthebottomsideofdevice. Pleaseinsertthecardcorrectlyastheiconshownonthecover:
Figure10 FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only. XAC Automation Corporation 886-3-577-2738 The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be disclosed, distributed or reproduced without permission of XAC Automation Corporation.