submitted | available | document details (if available) | source link |
---|---|---|---|
various | User Manual | Users Manual | 2.50 MiB |
PS20 Personal Shopper Quick Start Guide MN-003318-01 DRAFT PS20 Personal Shopper Quick Start Guide Copyright 2018 ZIH Corp. and/or its affiliates. All rights reserved. ZEBRA and the stylized Zebra head are trademarks of ZIH Corp., registered in many jurisdictions worldwide. Google, Android, Google Play and other marks are trademarks of Google LLC. All other trademarks are the property of their respective owners. COPYRIGHTS & TRADEMARKS: For complete copyright and trademark information, go to www.zebra.com/copyright. WARRANTY: For complete warranty information, go to www.zebra.com/warranty. END USER LICENSE AGREEMENT: For complete EULA information, go to www.zebra.com/eula. Terms of Use Proprietary Statement This manual contains proprietary information of Zebra Technologies Corporation and its subsidiaries (Zebra Technologies). It is intended solely for the information and use of parties operating and maintaining the equipment described herein. Such proprietary information may not be used, reproduced, or disclosed to any other parties for any other purpose without the express, written permission of Zebra Technologies. Product Improvements Continuous improvement of products is a policy of Zebra Technologies. All specifications and designs are subject to change without notice. Liability Disclaimer Zebra Technologies takes steps to ensure that its published Engineering specifications and manuals are correct; however, errors do occur. Zebra Technologies reserves the right to correct any such errors and disclaims liability resulting therefrom. Limitation of Liability In no event shall Zebra Technologies or anyone else involved in the creation, production, or delivery of the accompanying product (including hardware and software) be liable for any damages whatsoever (including, without limitation, consequential damages including loss of business profits, business interruption, or loss of business information) arising out of the use of, the results of use of, or inability to use such product, even if Zebra Technologies has been advised of the possibility of such damages. Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Warranty For the complete Zebra hardware product warranty statement, go to: www.zebra.com/warranty. Service Information Before you use the unit, it must be configured to operate in your facilitys network and run your applications. If you have a problem using your equipment, contact your facilitys Technical or Systems Support. If there is a problem with the equipment, they will contact the Zebra Global Customer Support at www.zebra.com/support. 2 DRAFT PS20 Personal Shopper Quick Start Guide For the latest version of this guide go to: www.zebra.com/support. Provide Documentation Feedback If you have comments, questions, or suggestions about this guide, send an email to EVM-Techdocs@zebra.com. Configurations This guide covers the following configurations:
Table 1 Configurations Configuration Radios Display Memory Data Capture Options Operating System PS20 Base WLAN: 802.11 a/b/g/n/d/h/i/k/r/v/ac WPAN: Bluetooth v5.0 WVGA 4.0 color 4 GB RAM/16 GB Flash SE2100 PS20 Plus WLAN: 802.11 a/b/g/n/d/h/i/k/r/v/ac WPAN: Bluetooth v5.0 WVGA 4.0 color 4 GB RAM/16 GB Flash SE4710 +
Digimarc Android Open Source Project
(AOSP)/
Google Mobile Services
(GMS) 8.1 Android Open Source Project
(AOSP)/
Google Mobile Services
(GMS) 8.1 3 DRAFT PS20 Personal Shopper Quick Start Guide Unpacking Carefully remove all protective material from the device and save the shipping container for later storage and shipping. Verify that the box contains all the equipment listed below:
PS20 (includes lithium-ion battery) Regulatory Guide Inspect the equipment for damage. If you are missing any equipment or if you find any damaged equipment, contact Support immediately. See Service Information on page 2 for contact information. Removing the Screen Protection Film A screen protection film is applied to the PS20 screen to protect the screen during shipping. To remove the screen protector, carefully lift the thin film off the touch screen display. Features Figure 1 Features - Front View Camera LED Status Microphone Touch Screen Scan Key 4 DRAFT PS20 Personal Shopper Quick Start Guide Table 2 Features - Front View Item Camera LED Status Microphone Touch Screen Scan Key Function Takes photos and videos. Available on Plus configurations. Indicates the battery charge state while charging or the scan/decode status. Red: Barcode scan in progress (Scan key is pressed). Single Green Blink: Successful decode. Use for communications in Speakerphone mode. Available on Plus configurations. Displays all information needed to operate the device. Indicates data capture when a scan application is enabled. Figure 2 Features - Back and Side View Scan Exit Window Speaker Branding Plate Slot Battery Cover Power Connector Table 3 Features - Back and Side View Item Scan Exit Window Speaker Function Provides data capture using the scanner. Provides audio output for video and music playback. 5 DRAFT PS20 Personal Shopper Quick Start Guide Table 3 Features - Back and Side View (Continued) Item Function Battery Cover Power Connector Provides device charging via charging cradles and used to perform a Encloses the battery and attaches to the devices handle. hard reset with the terminal reboot tool. Provides space for custom logo. Branding Plate Slot Setup To start using the device for the first time:
Charge the battery to at least 30% capacity. Charging the Battery To charge the battery:
1. Ensure the cradle is connected to the appropriate power source. 2. Insert the PS20 into a cradle. Figure 3 Single Slot Cradle 6 DRAFT PS20 Personal Shopper Quick Start Guide Figure 4 Three Slot Cradle The battery charges 0 to 90% depending on the following conditions, measured at room temperature:
When connected to a 1.0 cradle (normal charge mode), charge time is less than four hours. When connected to a 1.5 cradle (fast charge mode), charge time is less than three hours. NOTE To charge the battery in the device, it is recommended to use a charging cradle instead of the USB cable, since it is more time efficient. LED Status Indicators By default, the charging LED indication is disabled. To enable the charging LED indication:
1. Swipe down from the status bar to open the quick access panel and then touch 2. Touch Display. 3. Touch Charging LED. The option switch turns green. 4. Touch
. Table 4 LED Status Indicators LED State Imaging Off Indication Normal operation or PS20 is turned off. 7 DRAFT PS20 Personal Shopper Quick Start Guide Table 4 LED Status Indicators (Continued) LED State Red Single Green Blink Charging (PS20 docked in cradle) Off Blinking Green Solid Green Blinking Red Indication Imaging in progress (Scan key is pressed). Successful decode. Power not applied to cradle. PS20 not inserted properly. Charging LED feature disabled. Charging. Charging complete. Charging error, for example:
Temperature is too low or too high. Charging has gone on too long without completion (typically eight hours). Installing the Battery To install the battery:
1. Remove the screw that secures the battery cover, using a Phillips screwdriver. 2. Lift the battery cover from the handle. 3. Guide and press the battery cable connector into the shrouded male pin connector inside the battery compartment. The connector is designed to only fit one way. 4. Place the battery inside the battery compartment. 5. Place the battery cover onto the handle. 6. Secure the battery cover with the screw, using a Phillips screwdriver. 8 DRAFT PS20 Personal Shopper Quick Start Guide Figure 5 Installing the Battery Battery Cover Battery Cable Connector Battery Shrouded Male Pin Connector Battery Battery Compartment Compartment Removing the Battery To remove the battery:
1. Touch and hold the soft power button 2. Touch Power Off. 3. Touch OK. until the menu appears. CAUTION The PS20 must be off before removing the battery. Failing to turn off the PS20 before removing the battery may damage the data stored on flash memory or corrupt the operating system files. 4. Remove the screw that secures the battery cover, using a Phillips screwdriver. 5. Lift the battery cover from the handle. 6. Inside the battery compartment, press down the plastic tab of the battery cable connector and slide it out of the shrouded male pin connector. 7. Remove the battery from the battery compartment. 9 DRAFT PS20 Personal Shopper Quick Start Guide Figure 6 Remove the Battery Press down plastic tab to release Releasing the PS20 from the Charging Cradles Use one of the following methods to release the PS20 from the charging cradles:
Software Release Using the Menu Software Release Using the Cradle Utility Manual Release using a Release Key. Software Release Using the Menu The PS20 cradles contain a locking mechanism that locks the PS20 inside the cradle when docked. The PS20 releases from the cradle when a software command is received from the system. To remove the PS20 from the cradle using the menu:
until the menu appears. 1. Touch and hold the soft power button 2. Touch Cradle unlock. The cradle unlocks the PS20. 3. Remove the PS20 from the cradle. Software Release Using the Cradle Utility The PS20 cradles contain a locking mechanism that locks the PS20 inside the cradle when docked. The PS20 releases from the cradle when a software command is received from the system. To remove the PS20 from the cradle using the Cradle Utility:
1. On the Home screen, swipe up from the bottom of the screen. 2. Touch CradleUtility. 3. Tap the CRADLE UNLOCK tab to set the cradle unlock information. 4. Touch Unlock Cradle. 10 DRAFT PS20 Personal Shopper Quick Start Guide Manual Release Using a Release Key The PS20 cradles contain a locking mechanism that locks the PS20 inside the cradle when docked. If the PS20 fails to unlock during normal operation, use a release key to unlock the PS20. CAUTION Do not use any device to unlock the cradle other than the tools described below. Failure to comply could result in damage to the cradle and void the warranty. Manual Release of the PS20 from the Single Slot Cradle To release a locked PS20 from a Single Slot Cradle:
1. 2. While pressing the release key all the way into the slot, remove the PS20 from the cradle. Insert the release key into the slot located at the bottom side of the cradle. Figure 7 Manual Release of PS20 from a Single Slot Cradle Release Key Manual Release of the PS20 from the Three Slot Cradle To release a locked PS20 from a Three Slot Cradle:
1. 2. Hold the release key pressed inside the slot and remove the PS20 from the slot. Insert the release key straight into the slot, to a point where the bend stops. 11 DRAFT PS20 Personal Shopper Quick Start Guide Figure 8 Manual Release of the PS20 from a Three Slot Cradle Release Key Scanning To scan a barcode:
1. Launch a scanning application. 2. Press the Scan key and aim the device at a barcode. 3. Adjust the position of the device so that the red aiming dot appears at the center of the barcode. 4. Press the Scan key. The Status LED illuminates red. Upon successful decode, the Status LED changes from red to green and an audible beep sounds. Figure 9 Imager Illumination Frame Red Aiming Dot Red Illumination Frame Correct Incorrect 5. Release the Scan key. The barcode data displays on the screen. 12 DRAFT PS20 Personal Shopper Quick Start Guide Ergonomic Considerations Taking breaks and task rotation is recommended. Avoid Bending Figure 10 Avoid Bending Avoid Reaching Figure 11 Avoid Reaching 13 DRAFT PS20 Personal Shopper Quick Start Guide Avoid Extreme Wrist Angles Figure 12 Avoid Extreme Wrist Angles 14 DRAFT PS20 Personal Shopper Quick Start Guide 15 DRAFT www.zebra.com DRAFT
This product uses the FCC Data API but is not endorsed or certified by the FCC