Remote Control Model : EM-101R2 / EM-103MDR2 / EM-103SDR2/ EM-104R2 1. INTRODUCTION The transmitter allows you to operate the receiver. It is a visor mount type transmitter to allow to access easily. 2. LEARN TRANSMITTER TO THE RECEIVER UNIT In order for the transmitter to communicate with the receiver properly, the transmitter must be programmed to the receiver. Follow the brief instructions below or refer to the detail instructions from the Users Instructions to program the transmitter to the receiver. To program the transmitter to the receiver unit:
1. Connect the receiver unit RE-101 to 24VDC. 2. Press and hold the Learn button in the receiver. The ON LED will begin to flash. 3. Press the button on the transmitter for 1 second and release. 4. If a connection has been made, the ON LED on the receiver will stop flashing. 3. OPERATION Press the button for 1 second and release, this will activate the learned receiver. 4. BATTERY The remote transmitter operates on a 3-volt lithium battery that is installed at the factory. The battery does not need to be replaced if used under normal condition. Recommendation: Test your transmitter periodically to ensure that the battery is working. 5. FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. ISED :
6. This device complies contains licence-exempt transmitter that comply with Innovation Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes : (1) Lappareil ne doit pas produire de brouillage; (2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. 7. CUSTOMER SERVICE 9141-0720 Quebec Inc. DBA MANARAS/OPERA 136 Oneida Drive, POINTE-CLAIRE, QC, H9R 1A8 Canada Tel: 514-426-1332 Fax: 514-426-4330 Email: support@manaras.com Website: http://www.manaras.com