Incremental Packet Transmission -
Innovative 96 bit encryption to ensure the highest level of security for the transmission of codes. Each sequential transmission of code is different to prevent code grabber devices from operating.
SMT and SAW Technology - Surface Acoustic Wave resonators with SMT devices used in the design prevents problems with detuning and poor range performance.
Visual LED indicator A red LED light provides visual confirmation the device is transmitting. The CLIK64-M Series of battery-operated transmitters are wireless radio controls designed to be used with the CLIK64 Series of receivers. The CLIK64 transmitters use a very high level of security encryption to ensure the users identification code cannot be copied to gain unauthorized access to restricted areas. No coding switches are on the device. All programming credentials are factory set to ensure no duplication of identification codes. A 3-volt lithium battery CR2032 powers the transmitters. The batteries should last up to 3 years with normal use. To conserve battery life, an internal timer limits the transmission duration to a few seconds if the button is pressed for a long period of time. Simply release the button and press again to transmit. Operating Instructions 1. Press the button on the key tag transmitter assigned to release or trigger a device. A red indicator light will flash for the duration of the transmission. Press and holding the button down only transmits a short pulse. 2. Release and press the button again to send another transmission. 3. If the light on the transmitter does not light up when you press any button, replace the battery. Active Control Technology Inc., Mississauga, Ontario, Canada. Replacing Batteries 1. Carefully pry open the case with a flat edge tool or screwdriver from the key ring corner. 2. Make sure the case is laid flat on the table upside down. 3. Push out the coin shaped battery out of its holder and replace it with a similar battery being careful to place the + positive side on top. 4. DO NOT install the batteries backwards. The device will be damaged. 5. Snap close the case. 6. Test the transmitter and look for the red light to flash when a button is pressed. Radio frequency controls provide reliable and convenient means to remotely control devices. However, there are some limitations. A receiver can only respond to one transmission signal at a time and may be blocked by radio signals operating on the same center frequency. Important:
Warning:
Changes or modifications not expressly approved by Active Control Technology Inc. could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. Active Control Technology Inc., Mississauga, Ontario, Canada.