TRUSTED POWER INNOVATIONS Pack-Power System Quick Reference Guide Models:PP100-001 State of Charge (SOC):
Light flashing: System charging Llight: <25% charged 2 lights: 25%-50% charged 3 lights: 50%-75% charged 4 lights: 75%+ charged 4 lights, no flashing: 100% charged SuperSpeed USB 3.0 Hub:
Power and Bidirectional Data Active when Power ON USB Type A: Connect to devices (10W max per port) USB Type B: Connect to PC/Tablet Bluetooth Communications:
No light: Disabled To enable: Press Bluetooth button -
Flashing Blue indicates ready to pair Flashing Red: Paired Manual 91-0213 E 10 Walpole Park South, Walpole, MA 02081 Support: (617) 932-7877 or 844-RUPS-USA www.acumentrics.com 12VDC Regulated Output Blue: Providing Output Power 12V" symbol illuminated when active Red: Fault condition Note: 28VDC available as an option 10-30VDC Input (150W maximum) Blue: Connected to active power source Red: Fault Condition Bat Connector:
For future expansion capabilities Pushbutton ON/OFF: Blue: Unit ON No light: OFF Blue: ON Note 1: To reset after Fault Condition, turn unit OFF then ON. Note 2: To ensure long cycle life and safety, unit will enter Deep Sleep Mode after 24 hours at 0% SOC. To wake up unit out of Deep Sleep Mode, press power button twice within 3 seconds. Operational Guidelines Power Input:
Pack-Power is compatible with many sources, including solar panels, automobiles, military vehicles, external batteries, generators and wall outlets (viathe AC adapter). The system can accept up to 150W, which allows simultaneous full 100W output and battery charging. Note: Autostart (selected via PC App USB B) turns unit on upon application of input power Power Outputs:
Pack-Power provides up to 100W total continuous output including the VDC regulated output and USB hub. Each USB 3.0 Type A connector is capable of delivering up to LOW (SV @ 2A) Battery Charging:
0 to 100% SOC requires approximately 3 hours based on SOW charging power. Note 1: |n order for system to charge, input power must be at least 50W greater than the total load. Note 2: Use Deep Sleep Mode (user selectable) for extended shelf life Battery Runtime:
With a typical 10 W total mean load, Pack-Power delivers in excess of 9 hours runtime. At 100W continuous output, runtime is approximately 45 min. SuperSpeed USB 3.0 Data Hub:
In addition to providing power, the USB ports allow monitoring, control and transmit/received data exchange with a PC, tablet, or other devices. Compatible with USB 2.0 USB Remote Status Reporting:
The USB Data Hub also provides Pack-Power operational information, including SOC and charging status. This information can be displayed on a PC/tablet via the Acumentrics Pack-Power Application. Optional Bluetooth Communications:
Provides operational status and control functions via the optional Acumentrics Pack-Power Mobile Application (iOS / Android) Pack-Power System Quick Reference Guide Models: PP100-001 Acumentrics TRUSTED POWER INNOVATIONS
(551) Gcumentrics 1.60 2.06 2.533 3.61 4.86 5.76 6.69 Sg =
L = il TOP VIEW FRONT VIEW M4 x 2 PLACES EACH SIDE Connector Guide Contact Acumentrics for Accessory Kits VDC Output Connector VDC Input Connector DC 7.4mmoD / SmmiD Dc8.0mmOD/5.5mmID RIGHT SIDE VIEW
(TYP BOTH SIDES) Bat Connector For future expansion This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur ina particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
+ Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. As a general policy, Acumentrics does not recommend the use of any of its products in life support applications where failure or malfunction of the Acumentrics product can be reasonably expected to cause failure of the life support device or to significantly effect its safety or effectiveness. Acumentrics does not recommend the use of any of its products in direct patient care. Acumentrics will not knowingly sell its products for use in such applications unless it receives in writing assurances satisfactory to Acumentrics that (a) the risks of injury or damage have been minimized, (b) the customer assumes all such risks, and (c) the liability of Acumentrics is adequately protected under the circumstances. Examples of devices considered to be life support devices are neonatal oxygen analyzers, nerve stimulators (whether used for anesthesia, pain relief, or other purposes), auto transfusion devices, blood pumps, defibrillators, arrhythmia detectors and alarms, pace makers, hemodialysis systems, peritoneal dialysis systems, neonatal ventilator incubators, ventilators for both adults and infants, anesthesia ventilators, and infusion pumps as well as any other devices designated as critical by the U.S. FDA. Manual 91-0213 _E 10 Walpole Park South, Walpole, MA 02081 Support: (617) 932-7877 or 844-RUPS-USA www.acumentrics.com Key Specifications External Dimensions and Weight 1.54 x5.51"x7.48 / 2lbs Global Power Input (150W, 13A maximum) 10-30 VDC (up to 150W) 100-260 VAC / 47-63Hz with AC power supply Autostart feature (factory set) Power Outputs (100W Total Maximum Continuous) 12VDC +/- 5% Regulated, 28VDC optional 4x USB 3.0 Type A (Upto 10W each) Battery Charging:
3 hrs for 0% to 100% SOC @ SOW charging power Li-lon Battery Runtime:
9 hours at 1OW mean total load USB 3.0 Data Hub:
5 Gbit/sec maximum Mounting:
4x M4 threaded Holes (see Side View) Designed to Meet:
UN/DOT 38.3 FAA Carry on compliant 1PS4 Dust and Splashing Water Resistant (with connectors plugged in or covered) UL (AC adapter) Safety / Protection for Long Cycle Life:
Undervoltage, Overvoltage, Overcurrent, Overtemperature, Overpower Warranty:
One Year Limited information regarding accessories and options Page 2 of 2