Wall mount Installation Steps To install the SDX810-AP, refer to Figure 4 and complete the following steps. NOTE Do not mount the SDX810-AP above three meters from the floor. Wall Mount Installation To wall mount the SDX810-AP, complete the following steps:
Refer to Figure 4 when installing the SDX810-AP on a wall. 1. Determine a location for the SDX810-AP. Figure 4. Wall Mount Keyholes 2. Use the key holes on the back of the SDX810-AP as a template and install two #6 drywall anchors. 3. Install two 3.5*30L Pan Head screws.Leave approximately 1/4-inch (0.6 cm) protruding from the mounting surface. Refer to Figure 5. 4. Slide the SDX810-AP over the Pan Head screws and exert a small amount of downward pressure to ensure that the top of the slots are resting on the shafts of the Pan Head screws. or Figure 5. Place 3.5*30L Screws Safety and Regulatory Notice Safety and Regulatory Notice Scurit et Avis de rglementation Scurit et Avis de rglementation SDX810-AP April 2018 61287860F1-17A Mesh Access Point P/N: 1287860F1 English f WARNING!
this equipment. Read all warnings and cautions before installing or servicing Refer to the national, state and local electrical codes for the requirements for power and grounding wiring methods. f CAUTION!
This equipment contains no parts that can be serviced by the user. g NOTE This product meets EU RoHS Directive. Refer to www.adtran.com for further information on RoHS/WEEE. This device has been certified for use in Canada under Industry Canada (IC) Radio Standards Specification (RSS) RSS-247 and RSS-Gen. This Class B digital apparatus complies with Canadian ICES-003. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
1. This device may not cause interference, and 2. This device must accept any interference, including interference that may cause undesired operation of the device Digital apparatus CAN ICES-3 (B)/NMB-3(B) Radiation Exposure This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. This device is restricted to indoor use. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause interference, and 2. This device must accept any interference, including interference that may cause undesired operation of the device. Franais f AVERTISSMENT!
Lisez tous les avertissements et mises en garde avant linstallation de cet quipement ou la ralisation de toute opration de maintenance. Consultez les normes nationales, rgionales et locales sur les installations lectriques pour connatre les exigences en matire de cblage pour lalimentation et la mise la terre. f ATTENTION!
Il nexiste aucune pice pouvant tre rpare par lutilisateur lintrieur de cet quipement. g REMARQUE Ce produit est conforme la directive europenne RoHS. Reportez-vous www.adtran.com pour de plus amples renseignements sur RoHS. Cet appareil a t certifi pour utilisation au Canada en vertu des spcifications de normes radio (RSS) d'Industrie Canada
(IC) RSS-247 et RSS-Gen. Cet appareil numrique de classe B est conforme la norme canadienne ICES-003. Cet appareil est conforme aux normes RSS exemptes de licence d'Industrie Canada. L'opration est soumise aux deux conditions suivantes 1. Cet appareil ne peut pas causer d'interfrences, et 2. Cet appareil doit accepter toute interfrence, y compris les interfrences susceptibles de provoquer un fonctionnement indsirable de l'appareil. Appareil numrique CAN ICES-3 (B)/NMB-3(B) Exposition aux radiations Cet quipement est conforme aux limites d'exposition aux rayonnements IC RSS-102 tablies pour un environnement non contrl. Cet quipement doit tre install et utilis avec un minimum de 20cm de distance entre la source de rayonnement et votre corps. Cet appareil est limit une utilisation en intrieur. Shared Review 1 Franais English This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or experienced radio/TV technician for help. To satisfy FCC RF Exposure requirements for mobile and base station transmission devices, a separation distance of 20 cm or more should be maintained between the antenna of this device and persons during operation. To ensure compliance, operation at closer than this distance is not recommended. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Changes or modifications not expressly approved by ADTRAN could void the users authority to operate this equipment. This product is designed to operate with a nominal operating voltage of 12 VDC. The product is supplied with a power adapter, which operates from a main power source input of 100 - 240 V, 50/60 Hz, with a nominal output of 12 VDC. 2018 ADTRAN, Inc. All Rights Reserved. C A U T I O N !
SUBJECT TO ELECTROSTATIC DAMAGE OR DECREASE IN RELIABILITY HANDLING PRECAUTIONS REQUIRED ADTRAN CUSTOMER CARE:
From within the U.S. 1.800.726.8663 From outside the U.S. +1 256.963.8716 PRICING AND AVAILABILITY 1.800.827.0807
*61287860F1-17A*
Shared Review 1