BLUESOCKET COMPLIANCE NOTICE 1. INSTALLATION INSTRUCTIONS This document includes user requirements for operating ADTRAN Bluesocket products in accordance with national laws, including usage of radio spectrum and operation of radio devices. Failure of the end-user to comply with the applicable requirements may result in unlawful operation and adverse action against the end-user by the applicable national regulatory authority. ADTRAN Bluesocket products are intended to be installed, maintained, and serviced by qualified service personnel with knowledge of radio frequency (RF) and related rules. Particular attention should be given to allowed operation frequencies. The general user should not attempt to install Bluesocket wireless products outdoors when external antennas, power, and grounding must be installed for use. Refer to the specific Bluesocket products quick start guide (shipped with the unit or available online at https://supportforums.adtran.com) for information on installing, grounding, and powering the unit. Bluesocket products comply with radiation exposure limits set forth for an uncontrolled environment and meet RF exposure guidelines for wireless access points. Bluesocket products should be installed and operated keeping the product 65 cm or more away from a persons body. Use only the antennas which have been approved by ADTRAN for the specific Bluesocket product. Non-approved antennas may produce unwanted, spurious, or excessive RF transmitting power which may lead to the violation of local or national regulatory limits. During deployment of the system and its initial setup, professional installer must ensure that the allowed equivalent isotropically radiated power (EIRP) limit is not exceeded for the country in which the Bluesocket Access Point (BSAP) is deployed. The professional installer must enter the antenna gain in the BSAP GUI, using the following steps:
1. Access the BSAP as outlined in the Quick Start Guide that shipped with the unit. 2. On the Configuration tab, navigate to Wireless > Access Points. 3. Select the appropriate access point link to display the configuration menu. 4. Enter the antenna gain values (dBi) for the 2.4 GHz and 5 GHz frequency bands of ADTRAN approved antennas as outlined in the table below. BSAP Description Part Number Antenna Type Frequency Band Gain High Efficiency Omnidirectional Antenna Bundle 1925 High Efficiency Omnidirectional Antenna Bundle 1935 High Efficiency Omnidirectional Antenna Bundle 1940/2134 High Efficiency Omnidirectional Antenna Bundle 2035 1925 1935 1940 2035 1700932F1 Omnidirectional 2.4/5 GHz 3 dBi 1700931F1 Omnidirectional 2.4/5 GHz 3 dBi 1700930F1 Omnidirectional 2.4 GHz 5 GHz 5 dBi 7 dBi 1700957F1 Omnidirectional 2/4/5 GHz 3 dBi 2.4 GHz 13 dBi 5 GHz 7 dBi Dual Band HD Panel Antenna 2035 1700983F1 HD Panel 61700962F1-17B January 2016 BLUESOCKET COMPLIANCE NOTICE BSAP Description Part Number Antenna Type Frequency Band Gain High Efficiency Omnidirectional Antenna Bundle 1940/2134 1700930F1 Omnidirectional Dual Band Patch Antenna 2135 1700980F1 Patch 2135 5 GHz Mesh Panel Antenna 2135 1700981F1 Mesh Panel Dual Band HD Panel Antenna 2135 1700982F1 HD Panel 2.4 GHz 5 GHz 2.4 GHz 5 GHz 5 GHz 2.4 GHz 5 GHz 5 dBi 7 dBi 6 dBi 7 dBi 19 dBi 13 dBi 7 dBi Additional attenuation between the device and antenna may have to be calculated. Using the following formula, the EIRP limit can be calculated based on the transmit power of the radio, the selected antennas gain, and feeders (coaxial cable) loss:
EIRP Country Limit = RF Transmit Power (dBm) + Antenna Gain (dBi) - Feeder Loss (dB) Ce document comprend les besoins des utilisateurs pour lexploitation des produits ADTRAN Bluesocket, conformment aux lois nationales, y compris lutilisation du spectre radiolectrique et de lexploitation dappareils radio. Le dfaut de lutilisateur final de se conformer aux exigences applicables peut entraner une utilisation illgale et des poursuites contre lutilisateur final par lautorit rglementaire nationale comptente. Les produits ADTRAN Bluesocket sont destins tre installs, entretenus et rpars par du personnel dentretien qualifi ayant une connaissance de la frquence radio (RF) et des rgles relatives cette dernire. Une attention particulire devrait tre accorde aux frquences dexploitation autorises. Lutilisateur gnral ne devrait pas essayer d'installer des produits sans fil Bluesocket lextrieur quand des antennes externes, lalimentation lectrique et la mise la terre doivent tre installes l'emploi. Reportez-vous au guide de dmarrage rapide du produit Bluesocket particulier (livr avec lappareil ou disponible en ligne https://supportforums.adtran.com) pour obtenir des informations sur linstallation, la mise la terre et la mise sous tension de lappareil. Les produits Bluesocket sont conformes aux limites dexposition aux rayonnements dans un environnement non contrl et sont conformes aux directives dexposition RF pour les points daccs sans fil. Les produits Bluesocket doivent tre installs et exploits en gardant le produit une distance de 65 cm ou plus du corps dune personne. Utilisez uniquement les antennes qui ont t approuves par ADTRAN pour le produit Bluesocket particulier. Des antennes non approuves peuvent produire une transmission de puissance RF indsirable, parasite ou excessive qui peut conduire une infraction aux limites rglementaires locales ou nationales. Translation Needed 61700962F1-17B January 2016 BLUESOCKET COMPLIANCE NOTICE 2. FEDERAL COMMUNICATION COMMISSION (FCC) FCC Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Cautions Bluesocket products contain no user serviceable parts and are to be used with approved antennas only. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. Bluesocket products and their antennas must not be co-located or operated in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures. For outdoor use, antennas must be installed vertically to ensure that all emissions above 30 degrees elevation will not exceed the FCC 21 dBm EIRP limit. In Europe, Australia, and New Zealand, the 5 GHz U-NII low band (5.15 to 5.35 GHz, channels 36, 40, 44, and 48) is designated for indoor use only. If the BSAP 2135 is installed indoors, for example in a harsh environment such as a warehouse, it must configured for indoor use. For information on configuring a Bluesocket access point for indoor use, refer to the quick start guide that shipped with the product. FCC Radiation Exposure Statement Bluesocket products comply with FCC radiation exposure limits set forth for an uncontrolled environment and meet RF exposure guidelines for wireless access points. Bluesocket products should be installed and operated keeping the product 65 cm or more away from a persons body. 3. INDUSTRY CANADA (IC) IC Interference Statement This device complies with RSS-210/RSS-247 of the Industry Canada Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. 61700962F1-17B January 2016 BLUESOCKET COMPLIANCE NOTICE IC Caution
(i)
(ii) the device for operation in the band 5150 to 5350 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
the maximum antenna gain permitted for devices in the bands 5250 to 5350 MHz and 5470 to 5725 MHz shall be such that the equipment still complies with the EIRP limit;
(iii) the maximum antenna gain permitted for devices in the band 5725 to 5850 MHz shall be such that the equipment still complies with the EIRP limits specified for point-to-point and non-point-to-point operation as appropriate;
(iv) the worst-case tilt angle(s) necessary to remain compliant with the EIRP elevation mask requirement set forth in Section 6.2.2(3) shall be clearly indicated; and
(v) high-power radars are allocated as primary users (i.e., priority users) of the bands 5250 to 5350 MHz and 5650 to 5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices. Dclaration dinterfrence dIndustrie Canada Ce dispositif est conforme la norme CNR-210/CNR-247 dIndustrie Canada. Son fonctionnement est soumis aux deux conditions suivantes :
ce dispositif ne doit pas produire de brouillage prjudiciable;
ce dispositif doit accepter tout brouillage reu, y compris un brouillage susceptible de provoquer un fonctionnement indsirable. Avertissement dIndustrie Canada Le guide dutilisation des dispositifs pour rseaux locaux doit inclure des instructions prcises sur les restrictions susmentionnes, notamment :
i) ii) iii) iv) les dispositifs fonctionnant dans la bande 5150 5350 MHz sont rservs uniquement pour une utilisation lintrieur afin de rduire les risques de brouillage prjudiciable aux systmes de satellites mobiles utilisant les mmes canaux;
le gain maximal dantenne permis pour les dispositifs utilisant les bandes de 5250 5350 MHz et de 5470 5725 MHz doit tre conforme la limite de la PIRE;
le gain maximal dantenne permis pour les dispositifs utilisant la bande de 5725 5850 MHz doit tre conforme la limite de la PIRE spcifie pour lexploitation point point et lexploitation non point point, selon le cas;
les pires angles dinclinaison ncessaires pour demeurer conforme lexigence de la PIRE applicable au masque dlvation, et nonce la section 6.2.2 (3), doivent tre clairement indiqus;
v) de plus, les radars de forte puissance sont dsigns utilisateurs principaux (c.--d., quils ont la priorit) pour les bandes 5250 5350 MHz et 5650 5850 MHz et que ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL. IC Radiation Exposure Statement Bluesocket products comply with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 65 cm between the radiator and your body. Dclaration dexposition aux rayonnements dIndustrie Canada Les produits Bluesocket sont conformes aux limites dexposition aux rayonnements IC tablies pour un environnement non contrl. Cet quipement doit tre install et utilis une distance minimale de 65 cm entre la source de rayonnement et votre corps. 61700962F1-17B January 2016 BLUESOCKET COMPLIANCE NOTICE 4. EUROPEAN UNION (EU) EU Declaration of Conformity This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following test methods have been applied in order to prove presumption of conformity with the essential requirements of the R&TTE Directive 1999/5/EC:
EN 60950-1 EN 50385 EN 300 328 EN 301 893 EN 301 489-1 EN 301 489-17 61700962F1-17B January 2016