i A P WIRELESS EA RB UD S S S iTECH A P Earbuds OPERATING INSTRUCTIONS USING YOUR EARBUDS A B C D Fully charge your device before using. POWER ON Remove the earbuds from the charging case to power on each earbud. When both earbuds are on, they will automatically pair to each other within a couple of seconds. Control the earbuds by using the earbud touchpads:
Tap: play/pause, answer/hang up Double tap (L): Restart Track or go to Previous song POWER OFF Insert the earbuds into the charging case to shut down. You can also long-press the touchpad for 5 seconds to power them off. The light will flash red to indicate that they are powering off. Double tap (R): Next song Long press for 2 seconds: Reject call Long press for 5 seconds: Power on/off BLUETOOTH PAIRING The earbuds will pair to each other (left & right) automatically. When paired to each other, the left earbud will ash blue & Red and the right Earbud will stop ashing. Make sure your devices Bluetooth settings are turned on. The earbuds will appear as iT ch AMP Pro in your device list. Select iT ch AMP Pro to pair with your device. LED LIGHT INDICATOR Device Connected: no LED light (light off) Pairing Mode: Flashing RED AND BLUE CHARGING Working time:
Charging time*: ~1.5 hours (via hours cable)
*wireless charging times vary based on charger type REGULATORY NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits to provide reasonable protecon against harmful are designed interference in a residenal installaon. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instrucons, may cause harmful interference to radio communicaons. However, there is no guarantee that interference will not occur in a parcular installaon. If this equipment does cause harmful interference to radio or television recepon, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separaon between the equipment and receiver. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Changes or modicaons not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two condions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operaon. This equipment complies with FCC RF radiaon exposure limits set forth for an uncontrolled environment. This device and its antenna must not be located or operated in conjuncon with any other antenna or transmier. USER MANUAL Touchpad Earbuds Charging Case with USB charging port Wireless Charging Area (rear of case) FCC ID: 2AS3PITEAMPPRO