Manual for disassembly of bracket wireless charging Product Image:
Thank you for using this product Please read this manual carefully before use to ensure safe and correct use Product parameters:
Enter: DC5V/2A|DC9V/1.67A OutputDC9V/1A,7.5V/1A,5V/
1A Frequency Range: 110-205kHz Wireless Power:Max 10W How to 1. cross-stitch properly connected and ready the ones and to use;
twos in the picture;
3. Place the device on a 2. Connect the MICROUSB wireless charger and make sure cable to the MICROUSB port it is in a central position;
on the wireless charger and 4. When it is properly charged, connect the other end of the the charger indicator lights up cable to the USB port or the blue;
USBAC adapter (which uses the QC3.0 or PD protocol adapter), with a red light indicating that the charger is Points to note:
1. Keep the charger away from water or other liquids. 2. If you need to clean the device is placed on the wireless charger; make sure it is not charger; the FDO protection connected to the power supply. function is triggered, and the 3. The ambient temperature for indicator light flickers, unable use is approximately 0-40oC. to work properly. 4. . If your phone has a 6. When the charging protective case, you may need temperature is higher than 60 to remove it to successfully C, the NTC protection function connect when using a wireless is triggered, and the indicator charger. lamp flickers andean not work 5. When a non-rechargeable normally.
/ Certificate of \
/ Conformity \
Production date Inspector NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 Statements:
of the FCC Rules. Operation is This equipment complies with subject to the following two FCC radiation exposure limits set conditions:
forth for an uncontrolled
(1) this device may not cause environment. This equipment harmful interference, and (2) this shall be installed and operated device must accept any with minimum distance 20cm interference received, including between the radiator & body. interference that may cause undesired operation. RF Exposure Warning