FCC ID: 2AOKB-Y1822 Wireless Charging Dock

For FAQs and more information, please visit:

anker.com/support

@Anker Deutschland

@Anker Japan

@Anker Product Number: Y1822 5100500xxxx V01 Anker Wireless Charging Dock for Kindle Paperwhite (Signature Edition) QUICK START GUIDE 3sec 01 02 03 EN Solid white Flashing white Flashing red LED Indicator Status Solid white for 3 seconds, then turns off Connected to power Charging your device or fully charged Metal objects detected Overvoltage, undervoltage, or other abnormities T Your device can be used with an e-reader case. Make sure the case is not folded back when placing it onto the stand. Using a case more than 5 mm thick is not recommended as it may affect the wireless charging function. Important Safety Instructions Please refer to the electrical and safety information on the bottom before installing or operating the product. Avoid dropping. Do not disassemble. Do not expose to liquids. The maximum ambient temperature during use of this product must not exceed 40C. Open flame sources, such as candles, must not be placed on this product. Only use a dry cloth or brush to clean this product. WARNING: Only use attachments/accessories specified or provided by the manufacturer. FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio / TV technician for help. Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator & your body. Product Name: Anker Wireless Charging Dock for Kindle Paperwhite (Signature Edition) Model: Y1822 The following importer is the responsible party (for FCC matters only). Company Name: Fantasia Trading LLC Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764 Telephone: +1 800 988 7973 IC Statement This device complies with RSS-216 of Industry Canada. Operation is subject to the condition that this device does not cause harmful interference. RSS-Gen Issue 5 March 2019 This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference. 04 05

(2) This device must accept any interference, including interference that may cause undesired operation of the device. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RF exposure statement:

The equipment complies with IC Radiation exposure limit set forth for uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. Le prsent appareil est conforme aux CNR d' Innovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes :

(1) l'appareil nedoit pas produire de brouillage, et

(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Dclaration d'exposition RF: L'quipement est conforme la limite d'exposition aux radiations de la IC tablie pour un environnement non contrl. Cet quipement doit tre install et utilis avec une distance minimale de 20 cm entre le radiateur et votre corps. This product complies with the radio interference requirements of the European Community. Declaration of Conformity Hereby, Anker Innovations Limited declares that the product type Y1822 is in compliance with Directives 2014/53/EU & 2011/65/EU & 2014/35/EU

& 2014/30/EU & 2009/125/EC & 2019/1782/EU. The full text of the EU declaration of conformity is available at the following internet address:

https://www.anker.com/

GB Declaration of Conformity Hereby, Anker Innovations Limited declares that the product type Y1822 is in compliance with Radio Equipment Regulations 2017 & The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012 & Electrical Equipment (Safety) Regulations 2016 &

Electromagnetic Compatibility Regulations 2016 & The Ecodesign for Energy-

Related Products Regulations 2010. The full text of the GB declaration of conformity is available at the following internet address:

https://www.anker.com This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 20mm must be maintained between the users body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna. This device is in compliance with the essential requirements and other relevant provisions of UKCA. All essential radio test suites have been carried out. This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 20cm must be maintained between the users body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.This device in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. All essential radio test suites have been carried out. 1. The device complies with RF specifications when the device used at 20cm from your body. Specifications Adapter Input 100-240V~ 0.5A 50/60Hz Adapter Output 9V 1.5A, 13.5W Wireless Output 7.5W Max Adapter Average active efficiency 84.45%

Adapter Efficiency at low load (10%) 80.39%

06 07 Adapter No-load power consumption 0.06W Radiated H-Field 46.65dBuA/m (@3m) Tx/Rx Frequency Range 115-148KHz Anker Innovations Limited Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong Anker Innovations Deutschland GmbH Georg-Muche-Strasse 3, 80807 Munich, Germany Anker Technology (UK) Ltd Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11 2AA, United Kingdom Amazon, Kindle, and all related marks are trademarks of Amazon.com, Inc. or its affiliates Product Number: Y1822 Product Name:Anker Wireless Charging Dock for Kindle Paperwhite (Signature Edition) Indoor use only This symbol indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Customer Service 18-month limited warranty Lifetime Technical Support support@anker.com support.mea@anker.com (For Middle East and Africa Only)

(US) +1 (800)988 7973 Mon-Fri 6:15 - 17:00 (PT)

(UK) +44 (0) 1604 936200 Mon-Fri 6:00-17:00;

Sat-Sun 6:00-14:00

(DE) +49 (0) 69 9579 7960 Mo-Fr 6:00 - 11:00

(Middle East & Africa) +971 42463266 Sun-Thu 9:00 -

17:30

(UAE) +971 8000320817 Sun-Thu 9:00 - 17:30

(KSA) +966 8008500030 Sun-Thu 8:00 - 16:30

(Kuwait) +965 22069086 Sun-Thu 8:00 - 16:30

(Egypt) +20 8000000826 Sun-Thu 7:00 - 15:30

(AU) +61 3 8331 4800 Mon-Fri 8:30 - 17:00 (AEST)

(TR) +90 0850 460 14 14 Mon-Fri 9:00 - 18:00

(RU) +8 (800) 511-86-23 Mon-Fri 9:00 - 18:00 (MSK)

9:00 - 17:30

) +86 400 0550 036

) 03 4455 7823

+82 02-1670-7098 - 10:00 - 17: 00 9:00 - 17:00

08 09

Anker Innovations Limited COMPANY LETTERHEAD Date (2021-09-15) TUV SUD America Inc. 10 Centennial Drive Peabody, MA 01960, USA Dear Sir or Madam, We, (Anker Innovations Limited, Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, HONG KONG), hereby authorize Marlene Sealey of TUV SUD America, 10040 Mesa Rim Road, San Diego, CA, 92121 to act as our agent in all matters relating to applications for equipment authorization, including the signing of all documents relating to these matters. Type of equipment: Anker Wireless Charging Dock for Kindle Paperwhite (Signature Edition) Model name: Y1822 Yours sincerely, Name: Louis Qi Telephone Number:

13652441319 Email:

louis.qi@anker.com

Anker Innovations Limited Wireless charger approval FCC ID: 2AOKB-Y1822 Data: 2021-09-15 Theres a wireless charger that would like to have your authorization as an inductive wireless power transfer applications approval. The specific product as below, wireless quick charger, with its designed features and specified description, meets special requirement for KDB 680106 D01 v03 section 5 (b) requirements. Company:

Product Name:

Model Number:

FCC ID:

Anker Innovations Limited Anker Wireless Charging Dock for Kindle Paperwhite (Signature Edition) Y1822 2AOKB-Y1822 KDB 680106 D01 v03 section 5 (b) requirement:

Power transfer frequency is less than 1 MHz. Output power from each primary coil is less than or equal to 15 watts The transfer system includes only single primary and secondary coils. This includes charging systems that may have multiple primary coils and clients that are able to detect and allow coupling only between individual pairs of coils Client device is placed directly in contact with the transmitter Mobile exposure conditions only (portable exposure conditions are not covered by this exclusion). The aggregate H-field strengths at 15 cm surrounding the device and 20 cm above the top surface from all simultaneous transmitting coils are demonstrated to be less than 50% of the MPE limit. Product Technical Specification:

114.0KHz and 146.5KHz Max 7.5W Result:

Complied Complied Only single primary Complied Placed directly Complied Mobile exposure conditions only the detailed data please refer to RF exposure report Complied Complied Best Regards Company Officer:

Louis Qi Telephone Number:

13652441319 Email:

louis.qi@anker.com