FCC ID: 2AOU9-WCP Quad Lock Wireless Charging Pad

1. The device complies with RF specifications when the device used at 20cm form your body. Declaration of Conformity:

Hereby, Annex Products Pty Ltd declares that the product Wireless Charging Pad is in compliance with the following Directives:

Radio Equipment Regulations 2017, Electrical Equipment (Safety) Regulations 2016 and The Restriction of the Use of Certain Hazardous Substances in Electrical and Electrical Equipment 2012. The Full test of the UK declaration of conformity is available at the following internet address: https://www.quadlock.com.au/compliance Radiated H-Field

-5.18dBA/m (@10m)(only for EU and UK) TX/RX frequency range 110-148KHz (only for EU and UK) INDUSTRIE CANADA (IC: 27134-WCP) IC Caution:

Radio Standards Specification RSS-Gen, issue 5 This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the device. RF exposure statement:

The equipment complies with IC Radiation exposure limits set forth for uncontrolled environments. This equipment should be installed and operated with a minimum distance of 10cm between the radiator and your body. IC Caution:

Cet appareil contient des metteurs / rcepteurs exempts de licence conformes aux RSS (RSS) dInnovation, Sciences et Dveloppement conomique Canada. Le fonctionnement est soumis aux deux conditions suivantes:

(1) Cet appareil ne doit pas causer dinterfrences.

(2) Cet appareil doit accepter toutes les interfrences, y compris celles susceptibles de provoquer un fonctionnement indsirable de lappareil. Dclaration dexposition RF:

Lquipement est conforme la limite dexposition aux radiations de la IC tablie pour un environnement non contrl. Cet quipement doit tre install et utilis avec une distance minimale de 10 cm entre le radiateur et votre corps. 2. Manufacturer

* Name:

Chinese:

Contact: Charles Mao E-mail: Charles-m@huagon.cn

* Address:

Chinese: 38 3306 Tel: 18860301152 English: 306 3 Floor An hongji Xingyao Industrial Title: Product Manager District, Shenzhen City China 518109 KEEP IN TOUCH QUADLOCKCASE

@QUADLOCKCASE

@QUADLOCKCASE QUADLOCKCASE.NET POWER UP!

PLUGITIN FOREIGNOBJECTDETECTION Remove phone rings or wallets mounted on device as they will interfere with charging LEDLIGHTSTATES DAYMODE CHARGERBASE NIGHTMODE CHARGERBASE LIGHTSENSOR will automatically enter LED into Night Mode when the room is dark or the sensor is covered NO CHARGING CHARGING ERROR/

FOREIGN OBJECT DETECTION LIGHT GOES OFF AFTER 3 SECS LIGHT GOES OFF AFTER 3 SECS Annex Products Pty Ltd, Australia, declares that the products Wireless Charging Pad, complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: The Wireless Charging Pad has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules and has been assigned FCC ID: 2AOU9-WCP. These limits are designed to provide reasonable protection against harmful interference. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced technician for help. The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. Use only supplied antenna. CAUTION: Any changes or modifications in construction of these devices which are not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device was tested for operations. To comply with RF exposure requirements, a minimum separation distance of 20cm must be maintained between the users body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna. This device in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. All essential radio test suites have been carried out. This restriction will be applied to all Member States of European Union. 1. The device complies with RF specifications when the device used at 20cm form your body DeclarationofConformity Hereby, Annex Products Pty Ltd declares that the product Wireless Charging Pad is in compliance with Directives 2014/53/EU & 2011/65/

EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.quadlock.com.au/compliance This device was tested for operations. To comply with RF exposure requirements, a minimum separation distance of 20cm must be maintained between the users body and the charger, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna. The device is in compliance with the essential requirements and other relevant provisions of the UK Radio Equipment Regulations SI 2017:1206 (as amended). Plug USB cable into an 10W or higher power supply. NOTE:

Not recommended for use with a laptop (Some laptops may have enough power to deliver a slow charge to one product) This product contains magnets and components that generate strong electromagnetic fields. Keep your Quad Lock product a safe distance away from any sensitive or implanted medical devices. Consult with your medical practitioner or device manufacturer before use, or if you suspect the product is interfering with your device.

XXXXXX RoHS XXXXXXXXXXXXXX FCC ID: 2AOU9-WCP | IC: 27134-WCP INPUT DC: 5V/3A, 9V/2A, 12V/1.5A P/N: QL-4463 | HW: 1.0 | FW: 1.0 SKU: QLM-WCP Made in China Lable location 39mm

C5266091_X10_Ed.1 Annex Products Pty Ltd Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 Date: 6/22/2022 Subject: Request for Confidentiality FCC ID: 2AOU9-WCP To Whom It May Concern, Pursuant to the provisions of Sections 0.457 and 0.459 of Commission's rules

(47CFR0.457, 0.459), we are requesting the Commission to withhold the following attachment(s) as confidential document from public disclosure. Exhibits ID Label/Location Attestation Statement External Photos Block Diagram Schematics Test Report Test Setup Photos Users Manual Internal Photos Parts List / Tune Up RF Exposure Info Operational Description Cover Letter(s) SDR Software / Security Info Long-Term Confidentiality No No No No No No Short-Term Confidentiality No No No No No Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. Sincerely, Signature:

Name: Chris Peters Date: 6/22/2022 Title: Co-founder & CIO 1/1

C5266091_X8_Ed.1 Letter of Authorization Company: Annex Products Pty Ltd Address: Level 3 Suite 6A, 299 Toorak Rd, South Yarra VIC 3141 Australia Product Name: Quad Lock Wireless Charging Pad Model Number: QL-4463 FCC Identifier: 2AOU9-WCP We authorize LGAI Technological Center S.A., Ronda de la Font del Carme, s/n, 08193 Bellaterra, Spain, to act on our behalf on all matters concerning the above named equipment. Any individual within LGAI Technological Center S.A. is authorized to act on our behalf and take action on the application. We declare that authorize LGAI Technological Center S.A., Ronda de la Font del Carme, s/n, 08193 Bellaterra, Spain, is allowed to forward all information related to the approval project to the Federal Communication Commission and to discuss any issues concerning the approval application. Any and all acts carried out by LGAI Technological Center S.A. on our behalf shall have the same effect as acts of our own. Name: Chris Peters Date: 6/22/2022 Title: Co-founder & CIO Signature of applicant:

1/1