Caution
- Be sure to fly your "Flying Pterosaur only under adult supervision. :
- Do not fiy near cars, people, pets, overhead wires, bodies of water, buildings, trees, efc. Use common sense when operating your Flying Pterosaur! .
- Do not fly the Flying Pterosaur near high voltage electronic tower, strong wind area. Find an open area as large as a basketball court and fly away from
~ people, streets, houses, trees_or power lines. :
~ Keep fingers, hair and loose clothing away from the propeller while the Flying Pterosaur i is switched ON. To prevent entanglement, keep hair away from propeller. (Diagram A) :
_- Do not put foreign objects or tie material around the moving jeints such as the wings of Flying Pterosaur. Do not hold the wings while the Fiying Pterosaur is flapping. (Diagram 'B) Do not catch the Flying Pterosaur while itis flying. (Diagram C}
After each use, always turn OFF the Flying Pterosaur and remove alt batteries (controller) for storage. Never leave weak or dead batteries in the controller, as they may leak damaging chemicals.
- Charge the Flying Pterosaur by using the controller onlyydo NOT use any AC/DG adaptor with DC jack to plug inthe Flying Ptersaur to recharge.
- Remove all packaging material before giving the toy to your child. coat safes
. Do not use a damp cloth to clean or immerse the Flying Pterosaur in water for cleansing. Only use a dry cloth to clean off the dust. -
. Do not expose the radio contraller to water. If the controller is accidentally exposed te water, remove the controller battery and allow the controller to air-dry. Replace with a fresh battery before resuming operation. Do not bend the wings of Flying Pterosaur as this may affect its performance. (Diagram D'}
. Always move the power switch to Off when Flying Pterosaur is unattended or not in play. After about 5 minutes of running time, you should pay close attention to your Flying Pterosaur. The speed will be slower. For better performance, held the controller antenna upright and point at Flying Pterosaur. If your Flying Pterosaur gets too far away, it will not work properly. When Flying Pterosaur flies erratically, the problem is usually the result of interference caused by high tension wires, CB radios, or other R/C vehicles running nearby on the same frequency as yours. You may have to choose an alternative place to play. ? 4 8. Do notstore Flying Pterosaur or controller near heat or in direct sunlight. 9. When your Flying Pterosaur starts to lose power, it may lose functions or performance. Its time for fresh batteries (or a recharge). :
10. Your Flying.Pterosaurs flying time may change depending on your flying style. 11. Flying Pterosaur flies straight when theswings are LEVEL.
} 12. Keep the Flying Pterosaur within 100 feet of yourself. - i 13. Please be reminded to replace the side door to avoid missing, the wire can be pulled out while the door is kept in the side. (Diagram 'E%
14. Please note the controlled distance may be varied depending on the environment for playing indoor since the radio signal is affect by lots of obstacles. 15. Ha day or more passes without charging the Flying Pterosaur, or if you are unsure whether or not it is fully charged, discharge it, then fully recharge it, 16. Please try not to: play the Flying Pterosaur in strong.wind. The Flying Pterosaur will be out of your control and may be flied away finally. 17. While playing th Flying Pterosaur in the breeze, try to fly your Flying Ptrogaur i in the sky'then let if glice at the air without giving power. It can glide at the air for some distances. Give a little bit of power when the Flying Pierosaur tends 'to fly down, then it can glide at the air again. 48. Please play the Flying Pterosaur outdoor in a wide area when you are a beginner. While you think you are an expert, try this advance mode, to play the Flying Pterosaur indoor. Come challenge yourself by using the indoor power to control your Flying Plerosaur. :
Assebmly of propeller If you miss the propller in the,tail of the Flying Pterosaur, please assebmily the propeller before play it again. This product includes two spare propellers
+ Apply glue to the extended shai, insert the propeller into the shaft. Apply force on the propeller to the shaft for a moment until the propeller is fixed. Picking up your Flying Pterosaur after flight.
* Whenever you pick up the Flying Pterosaur, be sure to keep'your fingers away from the transmitter conirols until you can turn it off. It is easy to turn on the Flying Plerosaur accidentally while you or a friend is holding it before relaunch!
Broken Wing or Stabilizer
* Apply white glue to the broken areas, press them back into position then reinforce with clear cellophane tape.
* DO NOT USE SUPER GLUE. Super glue may cause unwanted effects to the foam which may result in irreparable damage. Repairs should be conducted under aduit supervision fo ensure safety. Teter Guide If you are experiencing difficulties with Flying Pterosaur, before calling our customer service hotline _ try checking these areas:
|| _Preblem Seton Flying Pterosaur does not work, |a} The batiery may be exhausted after not being use for a long.time. Recharge the batiery and try if again. LEDs(eye) are not lit though power is |b} The voltage of the battery is tao low to make the Flying Plerosaur fly. Recharge the battery and try it again. switched on. Flying Pterosaur is not responding to the] a) The control distance is too great and out of signal receiving range. Contral the Flying Pterosaur from less than 30m controller. to make the signal receive. Make sure that the antenna of the Flying Ptercsaur controller is fully extended. b) There is interference caused by high tension wires, CB radios, or other R/C vehiclesyunping nearby on the same frequency as yours. It is better choose an alternative place to fly, oO
) The batteries in controtler are exhausted, replace with fresh batteries. a} The wings of Flying Pterosaur may not be LEVEL. Adjust the wings to be the same LEVEL. Flying Pterosaur does not fly properly. Se Flying Pterosaur does not tum properly. a) There may be dust etc in the propeller in the tail of the Pterosaur. Check it and make sure it is clean and free of restrictions to allow it to rotate comectly. Instruction Manual FLYING = . PTEROSAUR _A bag of propeller includes v-wes+ three spare parts a
* Radio Controller
Operating instructions Please read through this instruction manual carefully before starting to operate.
~ It is recommended to operate the Flying Pterosaur under adult supervision. We recommend that children over 8 years old play with Flying Pterosaur. Please keep this instruction manual for future reference. ert easy
- 3 functions (Fly straight, turn left and right}
- Frequency: 27MHz / 40MHz / 49MHz (Refer to the label on the product)
~ Range up to 100 ft (30m) Seewthe antenna into the
~ 2 speeds (outdoor speed and indoor speed), rn i "+ |[ top Of..the controller. Tighten finger-tight. (Do-
eur ers not overtighten.) gy i Your Flying Pterosaur comes completely assembled. Ail you need to do is to insert the antenna into the controller unit.
| Battery Requirement | = |
6 AA size 1.5V batteries for radio controller . (Nate: For the best performance and longer play time, ALKALINE batteries are recommended. Batteries are not included in this package. }
Battery Installation
- Besure the power of controller is in the OFF position before installing batteries.
~ Unscrew the battery door on the back of the controller with a Phillips screwdriver and place 6 "AA" size 1.5V alkaline batteries (not included) into the battery compartment. Be sure the polarity of the batteries is correct according to the d iagram on the battery compartment. Replace the battery door and tighten the screw. Do NOT over tighten. BATTERY CONTACTS Bent or dirty battery contacts may result in loss of power. a 6xsize AA LR& 1.5V betteries Power Button www.aok-ltd.com
| eet rane Flying eee | ] } | |
IMPORTANT! Be sure your Flying Pterosaur is switched off.
@ Be sure the Flying Pterosaur's power is in the OFF position before charging.
@ Remove the battery cover of controller with a Phillips screwdriver. a _ Place 6 AA size 1.5 batteries into the controller following the battery pattern on the battery compartment. Replace the battery cover.
@ Pull out the wire from the side door of the controller and piug it into the body of the Flying Pterosaur.
@ Set the controller's power to the ON position. E
@ The recharge indicator (green LED on the controller) will be lit. It shows the Flying Pterosaur is charging. 3 ra ciple
@ It takes around 20 minutes to fully charge the Flying Pterosaur. When the recharge indicator turns off, Flying Pterosai Disconnect the wires, Cover the side door of the controller. Turn ON the Flying Pterosaur, your Pterosaur is ready to fly. ds fully charged.
@ Turn Of the Flying Pterosaur Insert 6 AA alkaline batteries into the back of the controller. wa .
- . @ Green LED light ON" indicates the Flying Pterosaur is in charging Turn Gn the Controller wt
* The battenwof Flying Pterosaur must be completely discharged before recharging. How To Operate Flying eerily nT A 2m | Full Power (For Outdoor. Use} .. -- -
- 7 & ? -
When you push level A" up, the'Flying Pterosaur starts to
. flap its wings. It flaps its wings more powerfully so make sure it has a large area to fly in. fe Fir] mI ha 80% Power (For indoor Use}
When you pull level A down, the Flying Pterosaur starts io flap its wings. Hf flaps its wings less powerfully fo enable it to fly in smaller areas and indoors, with enough spaces. Power Button
] indoor Power
~ Pull down the lever A. Outdoor Power Push up the lever A. Right Turn +
Keep Flying Pterosaur in power, and push lever "B" to the right to turn right. Left Turn (Aw )+(2 @) =
Keep Flying Pterosaur in power, and push lever B" to the left to turn lett. Ay Set the power of Flying Pterosaur to the On" " Position. The red LEDs(eye) of Flying Pterosaur will light up. 2) Turn the controller to On position. Red LED is lit means 3) Pull out the antenna for longer controllable distance. the Pterosaur Is "ON". SS 4) There are two levers in the controller. The ieft lever controls the speed while the right lever controls the direction. 5) Hold the body of the Flying Pterosaur, be carefully your hand does not stop the wings. :
6) Push left lever up of down to flap the Flying Pterosaur's wing before you launch the Flying Pterosaur into the sky. Push the left lever up for high speed, push downwards for low speed. Red LED on the controller will be it while pushing either lever. 7) Gently throw your Flying Pterosaur at a 20-30 angle of elevation. Do not throw it too hard. 8) After launching, you can control the direction with the right lever. fo 1) Tum the Flying Pterosaur into the wind and aim it at the landing area. 2) Descend the speed of Flying Pterosaur slowly by reducing the power (release the power lever to the original position). 3) The Flying Pterosaur will glide dewn slowly and finally make a landing. You just have to control the direction to decide your landing area. Een eee) 1) Always follow the instructions carefully. 2) Do not mix ofd and new batteries or batteries of different types: alkaline, standard (carbon-zinc} er rechatgeable (NIMH).
-3) Use.only batteries specified and be sure to insert item correctly by the @ and polarity markings. Always follow the toy and battery | manufacturer's in instruction. 4) Remove batteries when not in use. Always remove exhausted batteries fram the controller. Dispose batteries safely. 5) Non-rechargeable batteries are not to be recharged. 6) Batteyynstallatian should be done by an adult.
-1) Rectiargeable Flying Pterosaur is only to be charged under adutt supervision. 8) Only batteries of the same or equivalent type as recommended are to be used. Do not recharge other types of batteries. er -
9) Do not charge Flying Pterosaur for longer than specified in this instruction manual. :
10) Always unplug the wires when not in use. '
11) Never leave a rechargeable Flying Pterosaur unattended when charging. 42) Rechargeable batteries are not recommended for use in the controller.
+3) Never short-circuit the battery terminals. 14) Dispose of ald batteries promptly and properly; do not burn or bury them. 15} Do not dispose of batteries in a fire, batteries may explode or leak. 16} Bo not open a battery as @ may burst and release toxic liquids. 17) Bent or dirty battery contacts may result in Joss of power. 18) Should this product cause, or be affected by, iocal electrical interference, move it away from other electrical equipment. Reset (switching off and on again or removing and re-assemblying batteries) if necessary. 19) Charge the Flying Pterosaur by using the supplied charger(controller) only. i a FCC RULES This device complies with the Part 15 of ihe FCC Rules. Operation is subject to the following two conditions:
{1} This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause-undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and fourd to comply with the limits for a Class 8 digital device, pursuant to Part 15 of the FOC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can fadiate radio frequency energy and, # not installed and used in accardance with the instructions, ma use harmful interference ta radio communications. However, there is no guarantee that interference will riot occur in @ particular installation. if this equipment does cause harmful interferice to? *rgdio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: A
| ~ Reorient or relocate the receiving antenna. _
- Increase the separation between the equipment and receiver. -
- Connect the equipment into an oxilet on a circuit diferent from that to which the receiver is connected.
~ Consult the dealer or experienced radio/TV technician for help. Industry Canada Notice - Canada only This radiocommunication device complies with all the requirements of Industry Canada Standard RSS-310. Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation.
| TX RF = 27.145 MHz 80 dBuvim @ 3 m. TX RF = 40.680 MHz 76 dBuv/m @ 3m. TA RF = 49.860 MHz 74 dBuv/m @ 3 m. lf there is any problem with Fiying Pterosaur, please call our customer service hotline: (852) 2783 1288, Please do not return goods to retail stores directly.
\ Seca PAgcTriAN girls Tamas (jg s10 (lees OOM 0 Or 1O) Rome a Teli tom occa re AOK Limited. - Room 816, 8/F, Tower B, New Mandarin Plaza, 14 Science Museum Road. Tsim Sha Tsui. Kowloon, Hong Keng. Printed in China.