sushi PARAL User Manual Product: Remote Control Mail Box Alarm tem No :5608 Enclosure: Indication figure of prime parts, Installation =
1. Transmitter: Unscrew the nuts in the cover by using the screxdriver , then install one |
battery (12 , 234) according to the correct direction after opening the cover, then put fon the cover and then scree up the nuts . (showed as the i2lustration ) 2, Receiver Open the cover on the back of the battery box , install two battery (2A) according to the correct direction , then put on the cover (shoved as the Illustration) the eaitter sust be put avay in the interior, inwhere there is no nonaetal , and tho receiver also sust be put exay in the interior beyond the nonmagnetic , refrigerator , TY, metal Specification 1. Put dogn the transmitter on the level after installing the battery, let it enter the status of waiting .Once the transmitter is slanted, the ange! is less than 45 degrees, the wireless electrical wave signal will be transvitted at the moment , and reach to the receiver . |
2, When the enitter restore the status of level, stop to transeit the wave and go on waiting 3. Pirstly, the batteries are installed in the receiver, the receiver began to work and make the melody and flash at the same Line after receiving the signal from the emitter 4, The mebody will be shopped automatically within 8 seconds after receiving the signal the light won t flash constantly until pressing the reset key on the top of receiver (showedd fas the illustration }, and enter the status of waiting . 5, If the key on the side of receiver is put forvard to direction of MIN, volume. On the contrary, that meant big voluse, (showed as the i}ust 6. Please change the batteries, after using for a long tine hat meant sol]
ation) Cantion Changes or modifications to this unit not expressly approved by the party responsible for compliance will void the user s authority to operate the equiprent, Any change to the equipment will void FOC grant . Note:
This equipment has been tested and found to comply with the limits for a Class B digital device , pursuant to part 18 of the FCC rules ,These linits are designed to provide reasonable protection against haroful interference in a residential installation .This equipaeat generates, uses and can radiate radio frequency energy and , if not instatled and used in accordance with the instructfons jay cause harmful interference to radio communication However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause hareful interference to radio or televis reception , which can be determined by turning the equipsent off and on , the user is encourage to try to correct the interference by one or more of the following measures. reorient or relocate the receiving entenns |
Increase the separation between the equipaent and receiver Connect the equipsent. into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/ TV technician for help Transnitter The cover of battery box The cover of |
battery box