submitted | available | document details (if available) | source link |
---|---|---|---|
September 01 2006 | September 01 2006 | Adobe Acrobat 7.0 Image Conversion Plug-in |
various | Manual Pt1 | Users Manual | 2.98 MiB | September 01 2006 |
Wireless Broadband Router 4387WG User Manual 2003 All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of the seller. Disclaimer Information in this document is subject to change without notice. The material contained herein is supplied without representation or warranty of any kind. The seller therefore assumes no responsibility and shall have no liability of any kind arising from the supply or use of this document or the material contained herein. Trademarks Microsoft and Windows are registered trademarks of Microsoft Corporation. All other trademarks mentioned in this document are the property of their respective owners. Draft Version May 07, 2003 FAW:2.02.14.xx Safety Instr For Instal uctions lation Use only the type of power source indicated on the marking labels.
@ Use only the power adapter supplied with the product.
@ Do not overload wall outlet or extension cords as this may increase the risk of electric shock or file. If the power cord is frayed, replace it with a new one.
@ Proper ventilation is necessary to prevent the product overheating. Do not block or cover the slots and openings on the device, which are intended for ventilation and proper operation. It is recommended to mount the product with a stack.
@ Do not place the product near any source of heat or expose it to direct sunshine.
@ Do not expose the product to moisture. Never spill any iquid on the product.
@ Do not attempt to connect with any computer accessory or electronic product without instructions from qualified service personnel. This may result in risk of electronic shock or file.
@ Do not place this product on an unstable stand or table. For Using
@ Power off and unplug this product from the wall outlet when it is not in use or before cleaning. Pay attention to the temperature of the power adapter. The temperature might be high. e = After powering off the product, power on the product at least 15 seconds later.
@ Do not block the ventilating openings of this product. e When the product is expected to be not in use for a period of time, unplug the power cord of the product to prevent it from the damage of storm or sudden increases in rating. il For Service Do not attempt to disassemble or open covers of this unit yourself. Nor should you attempt to service the product yourself, which may void the users authority to operate it. Contact qualified service personnel under the following conditions:
If the power cord or plug is damaged or frayed. If liquid has been spilled into the product. If the product has been exposed to rain or water. If the product does not operate normally when the operating instructions are followed.
@ = If the product has been dropped or the cabinet has been damaged. e@ = If the product exhibits a distinct change in performance. FCC Information FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Conditions This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) this device must accept any interference received, including interference that may cause undesired operation FCC Caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This product uses the FCC Data API but is not endorsed or certified by the FCC