User manual PANEL SW [FB160]
Product name PANEL SW Model No. FB160 How to use PANEL SWFB160 1. Immobilizer System This product is equipped with immobilizer system to protect against theft. 2. How to set the immobilizer The immobilizer system is consists of the PANEL SW and immobilizer key. These are attached to the vessel by the operator at the factory or in field. 3. How to use the product User owns the immobilizer key.
(See the figure below) authenticate the code. can be possible not be possible. When to start the engine of the vessel, user hold the immobilizer key over the panel SW. At this time, the antenna that attached to PANEL SW and the immobilizer key built-in chip In case that the code inside the immobilizer key matches, engine starting and vessel operation In case that the code does not match, on the other hand, engine starting and vessel operation can PANEL SW [FB160]
NOTE
MIN
NOM 134.2
MAX
46 UNIT kHz dBuV/m @3m 4. Technical Specification Parameter Operating frequency RF Power 5. FCC(USA) certification This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. 6. ISED(Canada) certification This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference. operation of the device. 2. This device must accept any interference, including interference that may cause undesired Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :
1. Lappareil ne doit pas produire de brouillage;
2. Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement.