FCC ID: T8VCL9-904 Smart key

1. Overview User Manual Handsfree-System This product is an electric steering lock with Handsfree-System designed to prevent theft. Lock and Unlock of the steering, by moving the Lock bar (5). The system is composed of:

- The steering lock referred to as Main Unit (1), which provides the following functions:

User recognizer, by means of an Active Transponder (2) or a Passive Transponder (3). Enable and disable of the ignition of the bike.

- The smart key referred to as Active Transponder (2). It can also be used as an RFID transponder.

- The RFID transponder referred to as Passive Transponder (3).

- Antenna Unit (4) The Handsfree-System combines the transponder functionality (LF: Low Frequency) and the radio controller transmission (RF: Radio Frequency) to recognize the right user of the motorcycle. The Handsfree-System can manage the Fuel Tank Cap (6)'s open/close state. The system is integrated in CAN bus for all data transfer with the other electronic units on the motorcycle.

(4)

(1)

(6)

(2)

(5)

(3)

(7) The document hereon is the property of Asahi Denso Co., Ltd. Page 5 of 23 CL9_UserManual_V02.docx User Manual Handsfree-System Key ON (Unlocking of the steering) Active Transponder User recognition with the active transponder (2) is performed as described below:

A. Press the Lock-Unlock-Button (7) on the handlebar of the motorcycle less than 1.5 second. B. The Main unit (1) requires the transponder (2) for a radio frequency identification with an LF signal C. transmitted by the Antenna Unit (4). If the active transponder (2) is within a range of 1.5 m from the vehicle and the battery is adequately charged, replies to the Main unit (1) and starts authentication. D. After successful authentication, when unlocked state of Lock bar(5) is confirmed, T15 is turned ON and the engine can be started. Passive Transponder User recognition with the passive transponder (3) is performed as described below:

A. Press the Lock-Unlock-Button (7) on the handlebar of the motorcycle less than 1.5 second. B. If the passive transponder (3) is within a range of 3 cm from the Antenna Unit (4), replies to the Main unit

(1) and starts authentication. C. After successful authentication, when unlocked state of Lock bar(5) is confirmed, T15 is turned ON and the engine can be started. Key OFF When the motorcycle speed is below 3 km/h, Key OFF is initiated by pressing Lock-Unlock-Button (7) on the handlebar. Neither active transponder (2) nor passive transponder (3) are required for Key OFF Lock of the steering To lock the steering lock:

Stop the motorcycle, then put it on the side stand and steer the handlebar rightward or leftward to the lockable position. Hold down the Lock-Unlock-Button (7) and hold it depressed for more than 2 second or more. Then the Steering lock will be locked (the Lock bar of the system (5) comes out). Neither active transponder (2) nor passive transponder (3) are required for Key OFF Note: In case of failed locking of the steering lock, the signal LED will blink 4 times. Fuel tank cap management After successful key authentication with either 1.1.1 or1.1.2, the fuel tank cap (6) can be opened. The document hereon is the property of Asahi Denso Co., Ltd. Page 6 of 23 CL9_UserManual_V02.docx User Manual Handsfree-System Replacing the battery in the Active transponder

(A)

(B)

[Important]

Take special care (A) when removing the key battery. This symbol (B) warns the user about important use and maintenance instructions contained inside the documents provided with the equipment.

[Warnings / Caution]

Risk of battery leakage, heat generation, and explosion Do not expose the key to high temperatures, such as on the dashboard, and under direct sunlight. Do not mechanically crush or cut the key. Risk of explosion if the battery is replaced by an incorrect type Always use only the same or an equivalent type of CR2032 3.0 [V] coin batteries. Do not include a coin battery in your mouth. There is a risk of burns from chemical substances. This product contains a coin battery. If coin batteries are accidentally ingested, chemical burns, penetration of mucosal tissue, etc. or in the worst case, death may result in just 2 hours. Keep new and used batteries away from children. If the battery cover does not close securely, stop using the product and keep it away from children. If you suspect that a battery is might have been swallowed or placed inside any part of the body, seek immediate medical attention. The document hereon is the property of Asahi Denso Co., Ltd. Page 7 of 23 CL9_UserManual_V02.docx 1. 2. User Manual Handsfree-System Insert "screwdriver" into the dent of "Rear plastic cover". Raise the inserted "screwdriver" in the direction of the arrow and remove "Rear plastic cover". Insert "Coin" into the dent in "Coin battery cover", turn 90 degrees counterclockwise so that the OPEN position comes to , and remove "Coin battery cover". The document hereon is the property of Asahi Denso Co., Ltd. Page 8 of 23 CL9_UserManual_V02.docx User Manual Handsfree-System 3. Remove "Used coin battery" and replace it with "New coin battery" .

4. Attach "Coin battery cover" and use "Coin" to fix "Coin battery cover" by turning 90 degrees clockwise so that the CLOSE position comes to . 5. Attach "Rear plastic cover" with hooks in the order of (A) (B). The document hereon is the property of Asahi Denso Co., Ltd. Page 9 of 23 CL9_UserManual_V02.docx User Manual Handsfree-System

(B)

(A) The document hereon is the property of Asahi Denso Co., Ltd. Page 10 of 23 CL9_UserManual_V02.docx User Manual Handsfree-System 2. Installation notes Handsfree-System attachment Handsfree-System consists of Main Unit, Active Transponder, Passive Transponder and Antenna Unit. These are attached to a vehicle by factory/field personnel. Access to Active Transponder internal parts It is strictly forbidden to have access to the inner electrical components, except used battery to be replaced. Product modifications It is strictly forbidden to modify or tamper products included in the Handsfree-System including the Antenna Unit. If the product fails All damaged components, must be replaced. The document hereon is the property of Asahi Denso Co., Ltd. Page 11 of 23 CL9_UserManual_V02.docx User Manual Handsfree-System 3. Technical Specification Steering lock (Main Unit) Parameter NOTE Nominal voltage Operating voltage Operating temperature Storage temperature Operating current Sleep current Operating frequency Modulation Frequency channel Data rate RF Power Digital transfer controller operating frequency

MIN 11.8 8.5

-20

-30

NOM 12

133.8 134.2 ASK 1 channel

1.6

20 MAX 12.2 16.0

+70

+80 5500 100 134.6

25

UNIT V V mA A kHz

kbps dBV/m @3m MHz Smart key (Active Transponder) Parameter NOTE MIN NOM MAX UNIT Nominal voltage Operating voltage Operating temperature Storage temperature Operating frequency Modulation Frequency channel Data rate RF Power Digital transfer controller operating frequency

FSK 1 channel

2.1

-20

-30 3.0

3.3

+70

+80 433.54 433.92 434.30

2.4

13.56

70

V V MHz

kbps dBV/m @3m MHz RFID transponder (Passive Transponder) Parameter Operating temperature Storage temperature Modulation Frequency channel Operating frequency Data rate The document hereon is the property of Asahi Denso Co., Ltd. NOTE

FSK 1 channel High Low

MIN

-20

-30

121.9 131.7

NOM

123.6 133.7

MAX

+70

+80

125.9 136.2 8 UNIT

kHz kHz kBaud Page 12 of 23 CL9_UserManual_V02.docx User Manual Handsfree-System Label printing position and the date of manufacture Steering lock Smart key YY MM DD WW Year of manufacture Month of manufacture Day of manufacture Week of manufacture (January 1 is the first week) NNNN Manufacturing number The document hereon is the property of Asahi Denso Co., Ltd. Page 14 of 23 CL9_UserManual_V02.docx User Manual Handsfree-System FCC(USA) certification Product name Steering lock FCC ID T8VCL9 Smart key T8VCL9-904 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. ISED(Canada) certification Product name Steering lock IC 6505A-CL9 Smart key 6505A-CL9904 This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :

1. Lappareil ne doit pas produire de brouillage;

2. Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. The document hereon is the property of Asahi Denso Co., Ltd. Page 19 of 23 CL9_UserManual_V02.docx

CCXXxxYYyyyZzW FCC ID :T8VCL9-904 CNC ID : XX-99999 MODEL : CL9-904 S/N : YYWWXXXYYMMDDNNNN IC : 6505A-CL9904 IFETEL : ABCDE 1234-5678 ANATEL : HHHHH-AA-FFFFF SUBTEL : XXXX XXXX ASAHI DENSO CO.,LTD. AD1-CL9-904 MADE IN JAPAN Part Number: 61911267000

4D ASAHI DENSO 6-2-1 Somejidai, Hamakita-ku, Hamamatsu, Shizuoka 434-0046, Japan Date: January 13, 2020 UL Verification Services Inc. 47173 Benicia Street, Fremont, CA 94538 Applicant: ASAHI DENSO CO.,LTD. FCC ID: T8VCL9-904 To whom it may concern:

We, the undersigned, hereby authorize Rie Fujiwara of Consumer Technology Division, UL Japan, Inc. to act on our behalf in all manners relating to application for equipment authorization, including signing of all documents relating to these matters. Any and all acts carried out by UL Japan, Inc. on our behalf shall have the same effect as acts of our own. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. This authorization is valid until further written notice from the applicant. The application for the subject equipment has not been submitted to another TCB for certification. Sincerely Yours, Tomohiro Yaq uch TOMOHIRO YAGUCHI ASAHI DENSO CO.,LTD.

4D ASAHI DENSO 6-2-1 Somejidai, Hamakita-ku, Hamamatsu, Shizuoka 434-0046, Japan Request for Confidentiality Date: January 13, 2020 UL Verification Services Inc. 47173 Benicia Street, Fremont, CA 94538 Applicant: ASAHI DENSO CO.,LTD. FCCID : T8VCL9-904 To whom it may concern:

Please be advised that the following information is to be held confidential on behalf of us, referring to the FCC rules 0.457 and 0.459:

Block Diagram Theory of Operation Schematics Parts List The application contains technical information which we deem to be trade secrets and proprietary. If made public, the information might be used to the disadvantage of the applicant in the market place. Thank you for your attention to this matter. Sincerely, To mohiro Yaguchi TOMOHIRO YAGUCHI ASAHI DENSO CO.,LTD.